menu search
thumb_up_alt 1 like thumb_down_alt 0 dislike

Your answer

Can you give answer to this question ?

Upload an image:

Privacy: Your email address will only be used for sending these notifications.

2 Answers

It convert ac into pulsating dcvoltage using only half cycle of applied AC voltage the Basic circuit arrangement of half wave rectifier consist of only 1 diode which can only rectify half cycle of AC current at the time of negative of cycle diode is in Reverse bias condition there is no current flows through circuit
thumb_up_alt 0 like thumb_down_alt 0 dislike

working of Half wave rectifier


The half-wave rectifier circuit using a semiconductor diode (D) with a load resistance RL but no smoothing filter is given in the figure. The diode is connected in series with the secondary of the transformer and the load resistance RL. The primary of the transformer is being connected to the ac supply mains. The ac voltage across the secondary winding changes polarities after every half cycle of the input wave. During the positive half-cycles of the input ac voltage i.e. when the upper end of the secondary winding is positive w.r.t. its lower end, the diode is forward biased and therefore conducts current. If the forward resistance of the diode is assumed to be zero (in practice, however, a small resistance exists) the input voltage during the positive half-cycles is directly applied to the load resistance RL, making its upper-end positive w.r.t. its lower end. The waveforms of the output current and output voltage are of the same shape as that of the input ac voltage. During the negative half cycles of the input ac voltage i.e. when the lower end of the secondary winding is positive w.r.t. its upper end, the diode is reverse biased and so does not conduct. Thus during the negative half cycles of the input ac voltage, the current through and the voltage across the load remains zero. The reverse current, being very small in magnitude, is neglected. Thus for the negative half cycles, no power is delivered to the load. Thus the output voltage (VL) developed across load resistance RL is a series of positive half cycles of alternating voltage, with intervening very small constant negative voltage levels, It is obvious from the figure that the output is not a steady dc, but only a pulsating dc wave. To make the output wave smooth and useful in a DC power supply, we have to use a filter across the load. Since only half-cycles of the input wave are used, it is called a half wave rectifier. 

thumb_up_alt 0 like thumb_down_alt 0 dislike
← Prev Question Next Question →
Request Answer
Welcome to , where you can ask questions and receive answers from other user. Feel free to ask any question. Help everyone by giving best answer to the questions.

11,555 questions

10,176 answers


4,088 users