search
person
thyristor can be turned off by?

1 Answer

Thyristor can be turned off by making anode potential equal to cathode potential or by making anode potential less than cathode potential.
thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply frequency of A) 10 kHz B) 10 Hz C) 5 kHz D) 5 Hz 

Description : How is the GTO turned off? A) By using a commutation circuit B) By applying reverse gate pulse C) By using a latch-up circuit D) By reverse anode current pulse 

Answer : How is the GTO turned off? A) By using a commutation circuit B) By applying reverse gate pulse C) By using a latch-up circuit D) By reverse anode current pulse 

Answer : SCR turned off when the anode current falls below holding current.

Answer : No we cannot turn off normal thyristor using Gate.

Description : Draw the structural diagram of GTO. Explain briefly the switching behavior of GTO with the help of appropriate voltage and current waveform.

Answer : Gate Turn Off Thyristor (GTO) Conventional Thyristor can be turned on with gate terminal but can not turn off from gate terminal. But in case of Gate Turn Off Thyristor (GTO), we can turn it on and off ... subdivided as storage period (Ts), fall period (Tp) and tail period (Tt).

Description : In a 3-phase converter circuit during commutation when one SCR in one phase is turned on to turn-off an SCR in another phase, results in (A) voltage notching (B) harmonic distortion (C) voltage sag (D) voltage swell

Answer : In a 3-phase converter circuit during commutation when one SCR in one phase is turned on to turn-off an SCR in another phase, results in voltage notching

Description : A 100-watt light bulb turned on for 8 hours uses :  (A) 800 Wh (B) 0.8 kWh (C) 8 kWh (D) None of the above

Answer : A 100-watt light bulb turned on for 8 hours uses :  (A) 800 Wh (B) 0.8 kWh (C) 8 kWh (D) None of the above

Description : Thyristor can be protected from over voltages by using

Answer : Thyristor can be protected from over voltages by using Voltage clamping device

Description : parallel operation of MOSFET can be done more easily as compared to thyristor. why?

Answer : Parallel operation of MOSFET can be done more easily as compared to thyristor because the resistance of MOSFET is increases with increase in temperature. MOSFET have the positive temperature coefficient. In ... the parallel operation of MOSFET can be done more easily as compared to the thyristor.

Answer : GTO can be turned on by providing positive pulse to the gate terminal and it can be turn off by providing negative pulse to gate terminal.

Answer : The fuse blows off by melting.

Description : What is meant by pinch off voltage in MOSFET?

Description : Define pinch off voltage and drain resistance of FET.

Answer : 1 . Pinch-off Voltage: It is the value of the drain to source voltage VDS at which the drain current ID reaches its constant saturation value. Any further increase in VDS does not have any ... drain to source voltage to the change in drain current. It is also called AC/dynamic drain resistance.

Description : Explain the principle of ON-OFF control and phase control of AC voltage controller with suitable circuit and waveforms.

Answer : The integral cycle control (on-off control) and phase angle control are the two types of AC voltage controller. The principle of ON-OFF control: The on-off control is also called an integral cycle ... control. In phase control, the switch is on for some period of each cycle.  

Description : What is meant by firing angle of thyristor?

Answer : The point at which SCR is triggered is known as firings angle of thyristor.

Answer : By using some circuit the forward DC current of thyristor is forced to zero is called forced commutation.

Answer : Natural commutation is also called as line Communication. The turning off of thyristor due to AC supply is called natural commutation or line commutation. If the thyristor is connected to AC supply ... connected to positive and anode terminal get connected to negative, this turns off the thyristor.

Answer : Thyristor have three terminals anode, cathode and Gate.

Answer : Thyristor commutation means turning off thyristor.

Answer : Thyristor can only be turned on by small gate pulse but it cannot be turn off by using gate hence thyristor is called semi controlled device.

Answer : Thyristor can be turn on by positive gate pulse and the current will continue to flow through the device even when the gate voltage is low hence thyristor is called latching device.

Description : Describe the working principle of Thyristor operated dimmer with the help of circuit diagram.

Answer : Thyristor operated dimmer: A popular thyristor operated dimmer circuit employ TRIAC-DIAC phase control for low AC power control. During each half-cycle, the capacitor charges through (R1+VR1). When the ... time constant {C (R1+VR1)}. Thus by reducing VR1 the lamp brightness can be increased.

Description : Leakage current flows through the thyristor in

Answer : Leakage current flows through the thyristor in Forward blocking mode and Reverse blocking mode.

Description : What is a phase control thyristor?

Description : Why thyristor are not preferred for inverter?

Description : What is thyristor family?

Description : What is the use of a thyristor in a circuit?

Description : What is a reverse conducting thyristor?

Description : What is the function of a thyristor?

Description : Why SCR is called as thyristor?

Description : Is a SCR a thyristor?

Answer : Yes, SCR is a thyristor. Thyristor is the family and SCR is the member of that family but SCR is universally known as thyristor.

Description : How is a thyristor used to convert AC to DC?

Description : What is the application of thyristor?

Answer : Yes ,it is one of the main advantage using thristors as a  switch in DC  circuit ,it has a high current gain

Description : Explain thyristor gate drive circuit.

Answer : Thyristor Gate Drive Circuit: The thyristor can be turned on by pulse voltage signal at gate terminal and it does not require continuous drive signal like the transistor. The gate ... circuit provide required minimum gate voltage and gate current then the thyristor conducts properly.

Description : what are the disadvantages of thyristor?

Answer : Disadvantages of thyristor The silicon controlled rectifier (SCR) is unidirectional devices, so it can control power only in DC power during positive half cycle of AC supply. Thus only DC power is ... cycle. It cannot be used at higher frequencies. The gate current cannot be negative

Description : write short notes on thyristor CSI .

Answer : Current-source inverter (CSI) is an inverter with a DC current input. Current source inverters are most commonly used in very high power AC motor drives.

Answer : Thyristor conducts when the anode voltage is greater than cathode and when the current provided to Gate.

Description : Thyristor Switched Capacitor (TSC)

Answer : Thyristor Switched Capacitor (TSC)  TSC is a static compensator. TSC is use for compensating reactive power. Compensation is required for voltage regulation, increasing stability, ... compensating device like TCS phase angle between voltage and current can be maintain.

Description :  The silicon -controlled rectifier can be turned off : -  a) by a negative gate pulse b) by forced commutation c) with the off switch d) when the breakover voltage is exceeded

Answer :  The silicon -controlled rectifier can be turned off : - by forced commutation

Description : An SCR can only be turned off via it's   (A) cathode (B) anode (C) gates (D) none

Answer : An SCR can only be turned off via it's anode 

Description : Thyristor controlled phase angle regulator

Answer : Thyristor controlled phase angle regulator

Description : Two pumps M and N can separately fill a dumper in 36 minutes and 45 minutes respectively. Both the pumps are opened together but 12 minutes after the start the pump M is turned off. How much time will it take to fill the dumper? A) 9 min B) 10 min C) 30 min D) 32 min

Answer : C 12/36 + x/45 = 1 (12*5)/180+4x/180=1 60+4x=180 4x=120 X=120/4=30min

Description : Two pipes, Xand Y can fill a tank in 36 and 30 minutes respectively. Both are opened together, but at the end of 3minutes, X is turned off. In how many more minutes will Y fill the cistern? A) 7(24/5) B) 7(1/2) C) 24(1/3) D) 8(1/4) 

Answer : C X can fill cistern in 36 minutes. X fills cistern in 1 minute = 1/36 Y can fill cistern in 30 minutes. Y fills cistern in 1 minute = 1/30 part. Xand Y together can fill cistern in 1 minute, = {(1/ ... part. 147/180 part cistern must be filled by Y in, [(147/180)/(1/30)] = 24(1/3) minutes.

Description : Taps P, Q and R can fill a tank in 3, 4 and 5 hours respectively. If all the taps are opened together and after 30 minutes taps Q and R are turned off, find the total time in which the tank is full. A) 2(3/8)hrs B) 1(1/7)hrs C) 2(13/40)hrs D) 3(13/43)hrs

Answer : C In 1 hr P, Q, R = 1/3+1/4+1/5 = 20+15+12/60 = 47/60 Filled in 30m = 47/120 Remaining = 1-47/120 =73/120 Tap P = 3*73/120= 219/120 Total = 219/120+1/2 =219+60 /120= 279/120= 2 13/40 hrs

Description : what is TCSC?

Answer : Thyristor Controlled Series Capacitor (TCSC)

Description : The turn-off time of a thyristor is 30 is at 50°C. What is its turn-off time at 100°C ?

Answer : The turn-off time of a thyristor is 30 is at 50°C. What is its turn-off time at 100°C ? 60 microsecond

Description : Gate turn-off thyristor (GTO)

Description : A thyristor (SCR) turns off when the  A) Gate pulse is removed B) Gate pulse is applied C) Thyristor current is below holding value D) Anode voltage is made negative

Answer : A thyristor (SCR) turns off when the Thyristor current is below holding value

← Prev Question Next Question →
editAsk a Question
...