2 Answers

Answer :

Electric current is like water flow it flow from higher level to lower level and the electric potential of earth is zero so current is flow from higher voltage level to lower voltage level.
Like 0 like

Answer :

To avoid electric shock from electrical appliances to the human body 
Like 0 like

Related Questions

Description : A minimum clearance of 6.3 m to ground is required for overhead lines when operating voltages are :  (A) less than 66 kV (B) lie between 66 kV and 110 kV (C) more than 165 kV (D) lie between 110 kV and 165 kV

Last Answer : A minimum clearance of 6.3 m to ground is required for overhead lines when operating voltages are : lie between 66 kV and 110 kV

Description : Why do you need a closed circuit for electricity to flow?

Last Answer : When  the  circuit  is  closed  , a potential  diffrence  is  realized  between  the  two  nodes  connected  .This  causes  flow of  electrons  and  convection  current.

Description : How to Install an Above Ground Pool

Last Answer : How to Install an Above Ground Pool Having an above the ground pool would be a nice addition to your house. It can be a source of fun and recreation. There is even a good variety of above the ground ... for you to clean and balance out the pool's water. This should be done before you swim in it.

Description : How to Ground an Outlet

Last Answer : How to Ground an Outlet The industry standard for electrical outlets is that they must be grounded. On older homes and appliances, electrical outlets installed on the wall may not be grounded at all ... you can replace the old-fashioned electrical system in your home and replace it with safe ones.

Description : Describe the concept of virtual ground with reference to op-Amp.

Last Answer : Virtual ground concept:-In circuit point A is virtual ground. Figure shows inverting amplifier using op-amp. In this circuit non-inverting terminal is connected to the actual ground. Due to ... zero potential without actually grounding is known as virtual ground concept. Circuit diagram: 

Description : If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded transformer, then  (A) zero sequence currents are present on both sides of the transformer  (B) ... side  (D) zero sequence currents are present on the primary side but not on the secondary side

Last Answer : If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded transformer, then zero sequence currents are absent on both sides of the transformer 

Description : On the ladder resting on the ground and leaning against a smooth vertical wall, the force of friction will be?

Last Answer : On the ladder resting on the ground and leaning against a smooth vertical wall, the force of friction will be zero at its upper end.

Description : On a ladder resting on smooth ground and leaning against vertical wall, the force of friction will be?

Last Answer : On a ladder resting on smooth ground and leaning against vertical wall, the force of friction will be upwards at its upper end.

Description : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

Last Answer : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be at the slot edge where coil enters or comes out of the slot.

Last Answer : The ground wire should not be smaller than No 10 copper.

Description : necessity of transmission of electricity.

Last Answer :  Because of following points there is necessity of transmission of power:   1. Electrical load on power system is not concentrated at one place but it is widely spread.  2. Load ... to the point of actual utilization of it (consumers) for this purpose transmission electricity is necessary. 

Description : Describe the concept of Ferro electricity. Explain the application of Ferro electric material

Last Answer : The ferroelectric material has an electric dipole moment and it is spontaneously polarized. They have high dielectric constant which is nonlinear because it is dependent on the intensity of ... used in condensers to concentrate considerable quantities of electric energy within a small space. 

Description : List at least two examples that show how static electricity can be generated.

Last Answer : Examples of how static electricity can be generated include combing your hair, walking across a carpeted room, or sliding two pieces of plastic across each other.

Description : The consumer of electricity could be : (A) Domestic (B) Agricultural (C) Industrial and Commercial (D) All of the above 

Last Answer : The consumer of electricity could be : (A) Domestic (B) Agricultural (C) Industrial and Commercial (D) All of the above 

Description : The Central Electricity Regulatory Commission (CERC) is mainly responsible for:  (A) Regulating tariffs for generation and inter-state transmission of energy including tariffs  (B) Advising the government on ... (C) Efficiency and economy in the electricity industry  (D) All of the above

Last Answer : The Central Electricity Regulatory Commission (CERC) is mainly responsible for:  (A) Regulating tariffs for generation and inter-state transmission of energy including tariffs  (B) Advising the government on ... (C) Efficiency and economy in the electricity industry  (D) All of the above

Description : As per Electricity Act, ____________means any line which is used for carrying electricity for any purpose.  (A) Electric line (B) Transmission line (C) All of the above (D) None of the above

Last Answer : As per Electricity Act, Electric line means any line which is used for carrying electricity for any purpose. 

Description : What kinds of materials can not electricity pass through?

Last Answer : Electricity is generated at electrical power generation station.

Last Answer : Rubber is a insulator it do not allow flow of current so electricity can not flow through rubber.

Last Answer : No. Wood is an insulator and it doesn't free electrons to flow in it.

Description : How Household Use Electricity And Energy

Last Answer : I have often wondered what the average use of energy of appliances is. Here is a breakdown by percentage usage of each consuming appliance taken from a sampling of US households. Refrigerators 13.7% ... Telephone 0.2 Rechargeable Tools 0.2 Humidifier 0.1 Automobile Block Heater 0.0 Residual 7.3

Description : What is electricity?

Last Answer : Ans. It is a form of energy, which is invisible but can be felt by its effect.

Description : What is power in Electricity

Description : How Electricity is Made ?

Last Answer : How Electricity is Made Electricity is produced when the balance between the protons and electrons of an atom is disrupted by a certain force. It transmits an electrical charge through solid matter. ... as the classic Dutch six-bladed wind mills. These wind mills were used in ancient times.

Description : Define the terms: i) Tariff ii) Fuel surcharge iii) Electricity Duty iv) Connected load

Last Answer : i) Tariff: The rate at which a consumer is charged for the consumption of electricity is called as tariff. OR The amount of money framed by the supplier for the supply of electrical energy ... is the total wattage of all appliances which are used by the consumer on his sanctioned connection. 

Description : Define the following terms related to tariff: (i) Connected load (ii) Unit consumed (iii) Fixed charges (iv) Electricity Tax 

Last Answer : (i) Connected load  It is the sum of the power ratings (Watts or kW or MW) of all devices and machines existing (installed) in the premises of consumer. It is used to decide the ... a percentage of the total electricity bill which includes all amounts that go to the electricity supply agency. 

Last Answer : Integrating instruments are those which measure the total quantity of electricity delivered in a particular time.

Description : How do magnets and copper wire make electricity?

Last Answer : According  to  Faradays  law , a changing  magnetic  field  on  a  conductor  induses  current  in  the  conductor  through   mutual  induction.

Description : Is electricity generated in AC or DC?

Last Answer : Electricity   is  generated  in  AC.

Description : What do we use to generate electricity?

Last Answer : Use wind turbines.  In a windy seashore we set up some wind turbines.  But when the place is not windy we got no electricity.

Description : How much electricity is produced by a power plant?

Description : Is Aluminium a good conductor of electricity?

Last Answer : Yes aluminium is a conductor and it is a good conductor of electricity. But copper have better conductivity as compare to aluminium.

Description : How electricity is transmitted and distributed?

Description : How electricity is distributed?

Description : How much is 1 unit of electricity?

Last Answer : 1 unit of electricity is equal to 1 kWh.

Description : Is electricity faster than lightning?

Description : What speed does electricity travel at?

Description : Is it AC or DC electricity in the home?

Last Answer : Obviously its A.C

Description : How the electricity is transmitted?

Description : How is electricity passed through a wire?

Last Answer : A  wire contains  mobile  electrons  as  majority  charge  carriers  and  holes  as minority  charge carriers when  an emf  or   potential  diffrence is  provided , electrons  flow  in opposite  direction  with  holes(convection current  flow)

Description : How does the electricity travel?

Last Answer : Electricity can only travel when there is a force pushing it. This force is called electromotive force. Take a look at  a water pump. When you on it force(EMF)will be applied to the ... its specified destination. This same process is applied to  electricity. EMF is required to start the process. 

Description : How do we use nuclear energy to generate electricity?

Last Answer : nuclear energy is produce by nuclei of atom

Description : How does electricity get from the power plant to your home?

Last Answer : Electricity  gets  into   my   home  due  to  potential  diffrence  created   between  the  live   wire  and  neutral  wire.

Description : which device converts sound to electricity ?

Last Answer : Microphone converts sound to electricity.

Description : Indicate the three types oftransmissionline energylosses. a. I2R, R , and temperature b. Radiation, I2R, and dielectric heating c. Dielectric separation, insulation breakdown, and radiation d. Conductor heating, dielectric heating, and radiation resistance.

Last Answer : b. Radiation, I2R, and dielectric heating

Description : device connected in a circuit by using two way mention them

Description : Procedures when we connect conductor in a connector

Description : State method of insulation resistance. And explain dielectric absorption method.

Description : Do you think is DC better than AC to transmit energy?

Last Answer : In Long distance DC transmission will be better in cost. It requires more equipments for flexiblity In short distance AC transmission is better in  cost. It is more Flexible

Description : Why is the OCV capped at voltage setting? a) To save electricity b) To prevent exploding of the consumable c) Allow smooth transition into welding voltage range d) To reduce the risk of fatality

Last Answer : c) Allow smooth transition into welding voltage range

Show MoreNext Page → ← Prev Page