menu search
person

To measure an A. C. voltage by using an A.C. potentiometer, it is desirable that the supply for the potentiometer in taken?

1 Answer

To measure an A. C. voltage by using an A.C. potentiometer, it is desirable that the supply for the potentiometer in taken from the same source as the unknown voltage.

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description :

Answer :

The stator of phase shifting transformer for use in conjunction with an A.C. potentiometer usually has a two-phase winding.

Description :

When the voltage across a battery is measured using a D.C potentiometer, the reading shows 1.08 V. But when the same voltage is measured using a Permanent Magnet Moving Coil (PMMC) voltmeter, the voltmeter reading shows 0.99 V. If the resistance of the voltmeter is 1100 Ohm , the internal resistance of the battery, in Ohm , is (A) 150 (B) 100 (C) 50 (D) 200

Answer :

When the voltage across a battery is measured using a D.C potentiometer, the reading shows 1.08 V. But when the same voltage is measured using a Permanent Magnet Moving Coil (PMMC) voltmeter, ... resistance of the voltmeter is 1100 Ohm , the internal resistance of the battery, in Ohm , is 100

Description :

Answer :

To measure a resistance with the help of a potentiometer it is not necessary to standardise the potentiometer.

Description :

Answer :

In an AC. co-ordinate potentiometer, the currents in the phase and quadrature potentiometer are adjusted to be out of phase by 90°.

Description :

Answer :

The desirable static characteristics of a measuring system are accuracy, sensitivity and reproducibility.

Description :

The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply frequency of A) 10 kHz B) 10 Hz C) 5 kHz D) 5 Hz 

Description :

A rheostat differs from potentiometer in the respect that it?

Answer :

A rheostat differs from potentiometer in the respect that it has higher wattage rating.

Description :

Answer :

In order to achieve high accuracy, the slide wire of a potentiometer should be as long as possible.

Description :

Answer :

If a D.C. series motor is operated on A.C. supply, it will spark excessively, have poor efficiency, have poor power factor.

Description :

Answer :

Basically a potentiometer is a device for comparing two voltages.

Description :

Answer :

A potentiometer may be used for measurement of resistance, measurement of current, calibration of ammeter, calibration of voltmeter.

Description :

Draw the waveform of three phase AC supply voltage.

Description :

 An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

Answer :

 An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

Description :

Total instantaneous power supplied by a 3-phase ac supply to a balanced R-L load is

Answer :

Total instantaneous power supplied by a 3-phase ac supply to a balanced R-L load is constant

Description :

Why does a transformer only work with an AC supply?

Answer :

The transformer work depends on the induction as main principle ,for that AC is the right means

Description :

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be  (1) unaffected (2) decreased (3) increased (4) either decreased or increased depending on the direction of the DC field

Answer :

An unshielded moving iron voltmeter is used to measure the voltage in an AC circuit. The stray DC magnetic field having a component along the axis will be either decreased or increased depending on the direction of the DC field

Description :

The desirable properties of transformer core material are  (1) low permeability and low hysteresis loss. (2) high permeability and high hysteresis loss. (3) high permeability and low hysteresis loss. (4) low permeability and hysteresis loss.

Answer :

The desirable properties of transformer core material are high permeability and low hysteresis loss.

Description :

What are the desirable characteristics of ideal switch?

Answer :

Desirable characteristics of the ideal switch: It is desirable to have power switches characteristics closer to ideal switch. The ideal switch should have the following characteristics. Zero resistance when ... . 100% efficiency. Able to control power flow with zero power dissipation.

Description :

Answer :

Yes we can use potentiometer for measuring resistance.

Description :

An ac voltmeter using full -wave rectification and having a sinusoidal input has an ac sensitivity equal to  (1) 1.414 times dc sensitivity (2) dc sensitivity (3) 0.9 times dc sensitivity (4) 0.707 times dc sensitivity

Answer :

An ac voltmeter using full -wave rectification and having a sinusoidal input has an ac sensitivity equal to 0.9 times dc sensitivity

Description :

Explain how sinusoidal AC voltage is generated by using simple one loop generator.

Answer :

An electric current produced by means of electrical machine is known as generator which converts mechanical energy into electrical energy. When conductor cuts the magnetic flux, emf induced in it. (Faraday' ... upon position of armature. The nature of emf is alternating as shown by the waveform. 

Description :

Answer :

Yes it can...

Description :

A change of 4% in the supply voltage to an induction motor will produce a change of approximately

Answer :

A change of 4% in the supply voltage to an induction motor will produce a change of approximately 8% in the rotor torque

Description :

A d.c. potentiometer is designed to measure up to about 2V with a slide wire of 800 mm. A standard cell of emf 1.18V obtains balance at 600 mm. A test cell is seen to obtain balance at 680 mm. The emf0fthe test cell is  A)1.00V B)1.34V C)1.50V D)1.70V 

Answer :

A d.c. potentiometer is designed to measure up to about 2V with a slide wire of 800 mm. A standard cell of emf 1.18V obtains balance at 600 mm. A test cell is seen to obtain balance at 680 mm. The emf0fthe test cell is 1.34V

Description :

Assertion (A): For an effective classroom communication at times it is desirable to use the projection technology. Reason (R): Using the projection technology facilitates extensive coverage of course contents. (A) Both (A) and (R) are true, and (R) is the correct explanation. (B) Both (A) and (R) are true, but (R) is not the correct explanation. (C) (A) is true, but (R) is false. (D) (A) is false, but (R) is true.

Answer :

(B) Both (A) and (R) are true, but (R) is not the correct explanation.

Description :

An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms?

Answer :

An A.C. voltage is impressed across a pure resistance of 3.5 ohms in parallel with a pure inductance of impedance of 3.5 ohms, both resistance and inductance carry equal currents.

Description :

Analyze the effect of supply voltage on performance of LED as regards current, Lumen output, efficacy and life. 

Answer :

1) Effect on Current:- In LED current depends upon supply voltage, if voltage get changes then current also change but this change in current will be control by resistors which are connected in series.  2) ...   4) Effect on Life:- If supply voltage is not stable then life of LED get reduced. 

Description :

In a three-phase supply floating neutral is undesirable because it way give rise to?

Answer :

In a three-phase supply floating neutral is undesirable because it way give rise to unequal line voltages across the load.

Description :

‘PMMC instrument is not suitable to measure AC quantity’. State the reason.

Answer :

The direction of force exerted on moving coil depends on the direction of current flowing through moving coil. If the direction of magnetic field is kept constant, it produces unidirectional torque if the current is ... on the coil in one cycle to zero. Hence the meter cannot read A.C. quantities.

Description :

Answer :

To avoid the effect of stray magnetic field in A.C. bridges we can use magnetic screening.

Description :

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be

Answer :

We connected a 35V dc supply to a resistance of 600 Ohm in series with an unknown resistance R.A. voltmeter having a resistance of 1.2 kOhm is connected across 600 Ohm resistance and read 5v. The value of resistance R will be 2.4 kOhm

Description :

Is the power line voltage available in our homes a dc or an ac voltage?

Answer :

The power line voltage available in our homes is AC. Mobile dwellings are the most commonly DC-supplied homes and even then they tend to include AC supply for heavier loads.

Description :

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

Answer :

A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will not start at all.

Description :

The apparent power drawn by an A.C. circuit is 10 kVA and active power is 8 kW. The reactive power in the circuit is?

Answer :

The apparent power drawn by an A.C. circuit is 10 kVA and active power is 8 kW. The reactive power in the circuit is 6 kVAR.

Description :

The input of an A.C. circuit having power factor of 0.8 lagging is 40 kVA The power drawn by the circuit is?

Answer :

The input of an A.C. circuit having power factor of 0.8 lagging is 40 kVA The power drawn by the circuit is 32 kW.

Description :

While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then (A) It would over-run the other alternator (B) Its rotor will fall back in phase with respect to the other machine (C) Its portion of share in load will increase (D) Its power factor would be decreased.

Answer :

While keeping the excitation constant, if the steam supply of an alternator running in parallel with another identical alternator is increased, then Its portion of share in load will increase

Description :

The effective resistance of an iron-cored choke working on ordinary supply frequency is more than its true resistance because of?

Answer :

The effective resistance of an iron-cored choke working on ordinary supply frequency is more than its true resistance because of iron loss in core.

Description :

What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Answer :

What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Description :

Explain working of AC circuit breaker using SCR with circuit diagram.

Answer :

AC Circuit Breaker:  The circuit configuration of static AC circuit breaker using SCR is shown in the figure. When switch S' is closed, the SCRs T1 and T2 are fired in positive ... to non-availability of gate current. Thus the maximum time delay for breaking the circuit is one half-cycle.

Description :

For measurement of radio frequency ac signals __________ type meter is used

Answer :

For measurement of radio frequency ac signals thermo-couple type meter is used

Description :

The direction of rotation of an inverter fed 3-phase ac motor is reversed by (A) a mechanical reversing switch (B) reversing the input dc link voltage (C) operating the inverter as a rectifier (D) changing the sequence of switching

Answer :

The direction of rotation of an inverter fed 3-phase ac motor is reversed by changing the sequence of switching

Description :

The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of______degrees.

Answer :

The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of 45 degrees.

Description :

State the purpose of calibration of measuring instruments. Explain the procedure of calibration of D.C. voltmeter by using D.C. potentiometer.

Answer :

Purpose of calibration : Calibration is the process of evaluating and adjusting the precision and accuracy of measuring equipment. Proper calibration of an instrument allows people to have a safe ... calibration curve can be drawn by plotting the percentage error against the measured voltages. 

Description :

Answer :

If a D.C. motor is connected across the A.C. supply it will burn due to heat produced in the field winding by eddy currents.

Description :

Answer :

Overhead lines for power supply to tramcars are at a minimum height of 10 m.

Description :

Answer :

For high value of diversity factor, a power station of given installed capacity will be in a position to supply more number of consumers.

Description :

Answer :

If the synchronous motor, properly synchronised to the supply is running on no load and is having negligible loss then the stator current will be zero.

Description :

Answer :

The primary reason for low power factor is supply system is due to installation of induction motors.

Description :

Answer :

If the supply frequency to the transformer is increased, the iron loss will increase.

← Prev Question Next Question →
editAsk a Question
...