search
person

1 Answer

Series capacitors are used to compensate for line inductive reactance.

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Answer : Series capacitors on transmission lines are of little use when the load VAR requirement is small.

Answer : The capacitors used in single-phase capacitor motors have no polarity marking.

Description : Series reactors are used to

Answer : Series reactors are used to bring down the fault level within the capacity of the switchgear

Description : Series capacitive compensation in EHV transmission line is used to

Answer : To maintain voltage stability 

Description : State the use of shunt and series resistance used in extension of meter.

Answer : Use of shunt and series resistance: i) Use of shunt: To extend the range of Ammeter. ii) Use of series resistance: To extend the range of Voltmeter.

Description : Why capacitors are used to improve power factor?

Answer :  Capacitors generate reactive power instead of that drawn from source which is required by inductive loads.so it reduce the reactive current which is drawn from source to be drawn from capacitor.This control in Electric bills cost.

Answer : In a distribution system, in order to improve power factor, the synchronous capacitors are installed at the receiving end.

Description : Capacitors for power factor correction are rated in?

Answer : Capacitors for power factor correction are rated in kVAR.

Description : What are the different types of capacitors?

Description : Which capacitors are suitable for DC filter circuits?

Answer : Electrolytic capacitors are suitable for DC filter circuits.

Description : Capacitors

Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : State any four types of capacitors.

Answer : Types of capacitors: i) Air capacitor ii) Paper capacitor iii) Mica capacitor iv) Ceramic capacitor v) Electrolytic capacitor vi) Poly-carbon capacitor

Description : What is the charge on each capacitor when a 150 V is applied across two capacitors with values 5 μF and 10 μF, connected in series? A) 500 μC B) 0.5 μC C) 0.5 C D) None of these

Answer : What is the charge on each capacitor when a 150 V is applied across two capacitors with values 5 μF and 10 μF, connected in series? A) 500 μC B) 0.5 μC C) 0.5 C D) None of these

Description : The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as

Answer : The circuit has resistors, capacitors and semi-conductor diodes. The circuit will be known as non-linear circuit.

Answer : For measurements on high voltage capacitors, the suitable bridge is Schering bridge.

Answer : Series reactors should have low resistance.

Answer : If  equalising bar is connected to the 2 DC generators  the current will be equal in 2 generators irrespective of parallel connection so that we connect equaliser bar

Description : IDMT relays are used to protect the transformer against :  (A) Internal short -circuits (B) Open circuits (C) External short circuits (D) Oil leakage

Answer : IDMT relays are used to protect the transformer against : External short circuits

Description : Regulating-transformers are used in power systems for control of

Answer : Regulating-transformers are used in power systems for control of power flow

Description : Surge absorbers are used for protection against

Answer : Surge absorbers are used for protection against low voltage high frequency oscillations

Answer : The inverse definite mean time relays are used for over current and earth fault protection of transformer against internal short-circuits.

Answer : The single phasing relays are used for the protection of three phase motors.

Answer : Impedance relays are used for phase faults on long line.

Description : Two resistors are said to be connected in series when?

Answer : Two resistors are said to be connected in series when same current passes in turn through both.

Answer : In a A.C. series motor armature coils are usually connected to commutator through resistance.

Description : Cells are connected in series in order to?

Answer : Cells are connected in series in order to increase voltage available.

Answer : A.C. network analyser is used to solve problems of load flow, short-circuit and stability.

Answer : Wave trap is used to trap waves of higher frequencies entering generator or transformer units.

Description : what is equivalent resistance when four 4 Ohm resistors are connected in i) series ii) parallel

Answer : equivalent resistance

Description : A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is

Answer : A series R-L-C Circuit has a resonant frequency of 1000 Hz. If the values of R, L and C are doubled, the new resonant frequency is 500 Hz

Description : Two 100W, 200V lamps are connected in series across a 200V supply. The total power consumed by each lamp will be in Watts

Answer : 4800

Description : What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Answer : What is the total resistance if 5 resistors of 20 Ω each are connected in series? A) 100 Ω B) 4 Ω C) 20 Ω D) None of these

Description : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

Answer : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across Rl.

Answer : When two D.C. series motors are connected in parallel, the resultant speed is normal speed.

Description : What are the advantages of DC series motor?

Description : Light triggering is mainly used in

Answer : Light triggering is mainly used in High voltage direct current transmission

Description : A relay used for protection of motors against overload is :  (A) Impedance relay (B) Electromagnetic attraction type (C) Thermal relay (D) Buchholz's relay

Answer : A relay used for protection of motors against overload is : Thermal relay

Description : Earthing switch is used for?  (A) Measuring of safety voltage (B) Protection of equipment from ground faults (C) Discharging residual energies (D) All of the above 

Answer : Earthing switch is used for?  (A) Measuring of safety voltage (B) Protection of equipment from ground faults (C) Discharging residual energies (D) All of the above 

Description : Auto reclosing is used in case of

Answer : Auto reclosing is used in case of air blast C.B.

Description : A negative sequence relay is used for protection of  (1) Generator (3) Motor (2) Transformer (4) Long Transmission lines

Answer : A negative sequence relay is used for protection of Generator 

Description : The material used in liquid fuses is  (1) SF6 (3) carbon tetra chloride (2) distilled water (4) transformer oil

Answer : The material used in liquid fuses is  carbon tetra chloride

Description : ln a minimum oil circuit breaker the oil is used

Answer : ln a minimum oil circuit breaker the oil is used to act as circuit breaking medium only

Answer : A switchgear is device used for switching, controlling and protecting the electrical circuit and equipment.

Answer : The material used for fuse must have low melting point and high specific resistance.

Answer : The under voltage relay can be used for generators, busbars, transformers, motors.

Answer : Air blast circuit breaker is used for repeated duty.

Description : State the modification to be done in dc series motor to work satisfactorily as ac series motor. State applications of ac series motor.

Answer : Modifications are necessary in a dc series motor so that it operates satisfactorily on ac supply. The modifications are as follows:  1) AC series motor is built with a few field turns as ... and grinders 5) High speed vacuum cleaners 6) Sewing machines 7) Food processors 8) Drilling machine 

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Description : An inductor is connected in series with SCR to protect it from A) Excessive high voltage B) Excessive high dv/dt C) Excessive high di/dt D) Excessive large forward current 

Answer : An inductor is connected in series with SCR to protect it from Excessive high di/dt

← Prev Question Next Question →
editChoose topic
...