search
person

1 Answer

Ungrounded neutral transmission system is not recommended because of system insulation being overstressed due to over voltages, insulation overstress may lead to failure and subsequent phase to phase faults, being inadequately protected against ground fault.

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : Explain following techniques related to energy conservation in transmission and distribution system. (i) By balancing phase currents (ii) Variable technical losses (I2R losses).

Answer : (i) Balancing Phase currents: Proper (healthy balanced) three phase loads always draw equal currents in all lines but single phase loads in the 3 phase 4 wire system or loads connected between two ... . 11) Minimize I2R losses. 12) Balance the load currents. 13) Regulate the system voltages.

Description : The permissible voltage variation in transmission and distribution system is:  (A) ± 0.1% (B) ± 1% (C) ±10% (D) ± 25%

Answer : The permissible voltage variation in transmission and distribution system is: ±10%

Description : In voltage source converter based HVDC transmission system the active power is controlled by changing (A) phase angle of the converter ac input voltage (B) supply frequency of the converter ac input voltage (C) magnitude of the converter ac input voltage (D) DC voltage at the inverter terminals

Answer : In voltage source converter based HVDC transmission system the active power is controlled by changing phase angle of the converter ac input voltage

Description : If a 5-bus test system contains 6 transmission lines and one transformer, how many non-zero elements are there in the system Y-bus ? (A) 25 (B) 12 (C) 11 (D) 19

Answer : If a 5-bus test system contains 6 transmission lines and one transformer, 19 non-zero elements are there in the system Y-bus.

Description : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ?

Answer : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ? Δ-Δ connection

Description : In a three-phase supply floating neutral is undesirable because it way give rise to?

Answer : In a three-phase supply floating neutral is undesirable because it way give rise to unequal line voltages across the load.

Answer : Due to no potential difference between the ends of the circiut there is no existance of current 

Description : What happens when a neutral wire touches a phase wire ?

Answer : Maximum current flow due to Short circuit, limited value of fuse will burn else apparatus and conductor will be damaged.

Description : Explain the meaning of following terms: i) MCB ii) Socket outlet iii) Neutral iv) Fuse-link

Answer : i) MCB:  Miniature circuit breaker operates automatically at the time of fault or over load. And it is used for the protection of electrical installation. They are available from 0.5 A to 100 Amps. ... melts automatically at the time of fault or over load. Fuse must be replaced after the fault.

Description : The magnetic neutral plane shifts in a dc machine (A) in the direction of motion of motor (B) in the direction of motion of generator (C) due to increase in the field flux (D) cause reduction of flash over between commutator segments

Answer : The magnetic neutral plane shifts in a dc machine in the direction of motion of generator

Answer : In a D.C. generator the magnetic neutral axis coincides with the geometrical neutral axis, when there is no load on|he generator.

Description : Which color wire is neutral?

Answer : Black but I think it depends with the place.

Description : The voltage of transmission can be regulated by  (A) Use of tap changing transformers (B) Switching in shunt capacitors at the receiving end during heavy loads (C) Use of capacitors to neutralize the effect of series reactance (D) Any of the above methods

Answer : The voltage of transmission can be regulated by  (A) Use of tap changing transformers (B) Switching in shunt capacitors at the receiving end during heavy loads (C) Use of capacitors to neutralize the effect of series reactance (D) Any of the above methods

Description : Transmission efficiency of a transmission line increases with the

Answer : Transmission efficiency of a transmission line increases with the increase in power factor and voltage

Answer : Reactance relay is preferred for phase fault on short transmission line.

Answer : When a wave propagates on a transmission line, it suffers reflection several times at sending and other end.

Answer : The interaction between a transmission line and communication line is minimized by transposing transmission as well as communication lines, increasing the height of the transmission line tower, increasing the distance between the two lines.

Answer : When a transmission line is energized, the wave that propagates on it is current wave and voltage wave.

Answer : A transmission line is protected by distance protection, time graded and current graded overcurrent protection.

Description : A differentiator is not usually used in control system, because it : - (A) reduces damping  (B) increases error  (C) reduces gain margin  (D) increases input noise

Answer : A differentiator is not usually used in control system, because it : - increases input noise

Description : Why is transmission line 11kV, 33kV 66kV Not Is 10kV, 20kV, 30kV ?

Answer : 10kv plus to compensate losses in olden days 1kv were added and transmitted. Since all equipment used for transmission have a multiple of 11 from olden days, still that is being followed even though the losses are ... voltages, multiples of 11 is eazy for winding ratios.. i.e. 11kv to 33kv is 1:3.

Description : Why are overhead transmission lines not insulated?

Answer : Insulators are useful to help separate electrical conductors when they come into physical contact. Overhead Transmission Lines Are Not Insulated: The overhead transmission line is carrying extreme high voltage and ... a whole lot of thick insulation to absorb the heat produced by such high voltage.

Description : In quadrilateral speed-time curve of electric traction system, the accelerations during successive time periods are ______ respectively.  (A) positive, negative and negative (B) positive, zero and negative (C) positive, positive and negative (D) positive, negative and zero

Answer : In quadrilateral speed-time curve of electric traction system, the accelerations during successive time periods are positive, negative and negative respectively. 

Description : A lightening arrester connected between the line and earth in a power system  (1) protects the terminal equipment against travelling surges (2) protects the transmission line against direct ... suppresses high frequency oscillations in the line (4) reflects back the travelling wave approaching it

Answer : A lightening arrester connected between the line and earth in a power system protects the terminal equipment against travelling surges

Description : For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is

Answer : For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is 25 x 25

Description : With fault clearing time, the transient stability of a power system

Answer : With fault clearing time, the transient stability of a power system decreases

Answer : In a single bus-bar system there will be complete shut down when fault occurs on the bus itself.

Answer : A balanced 3-phase system consists of positive sequence currents.

Answer : The steady state stability of the power system can be increased by connecting lines in parallel.

Answer : Air blast circuit breakers for 400 kV power system are designed to operate in 50 millisecond.

Answer : The contacts of high voltage switches used in power system are submerged in oil. The main purpose of the oil is to extinguish the arc.

Description : State the limitations of EHVAC transmission line. 

Answer : Following are the Limitations of EHVAC Transmission:   1. Insulation cost increases as voltage increases 2. Skin effect is more 3. Proximity effect is more. 4. Corona loss increases. 5. Radio ... 18. EHVAC is economical only for bulk amount of power is to be transmitted over long distance. 

Description : State the effects of low power factor on efficiency and voltage regulation of short transmission lines. 

Answer : i) Effect of Low power factor on efficiency:- When power factor of load reduces current drawn by transmission line increases so copper losses in transmission line increases, hence transmission ... increases, so voltage drop in transmission line increases so regulation increases. (Become Poor) 

Description : State the advantages of use of high voltage in transmission of Electric power. 

Answer : Advantages: 1. As Transmission voltage increases, current decreases. 2. As current decreases, cross section of conductor decreases. 3. As cross section of conductor decreases, its ... high voltage transmission line, successful interconnection of transmission line is possible than low voltage. 

Description : Differentiate between overhead transmission and underground transmission.

Answer : Points Overhead line  Underground cable Capital cost  Less More Erecting cost  Less More Time require for completion of work Less More Flexibility More ... Space consumed Space consumed  No space consumed Appearance Not good  Very good 

Description : State line parameters of transmission line. 

Answer : Following are the of Line parameters of transmission line:  1. Resistance  2. Inductance  3. Capacitance

Description : State features of wireless power transmission. 

Answer : Features of wireless power transmission:  1. Energy delivered anywhere in the world 2. Zero fuel cost 3. Less losses 4. Less use of copper wires 5. More efficiency 6. Minimum long- ... on cables would never exist in the transmission.  7. Power theft would be not possible at all. 

Description : State the classification of transmission lines depending on length of transmission lines. 

Answer : A) According to Voltage level: ( 2 Marks)  a) High voltage Transmission Line (HV) up to 33 KV  b) Extra High Voltage Transmission Line (EHV) above 33 KV up to 400 KV  c) Ultra ... Transmission Line: - The length of Long transmission Line is above 200KM and its line voltage is above 100KV

Description : State the impact of inductance and resistance on transmission line performance

Answer : Impact of inductance on transmission line: 1) It causes IXL drop in transmission line which affects regulation. 2) It is the only parameter which decides power transmission capacity of line i. ... is very small, it causes losses, temperature rise& poor voltage regulation so it cannot be neglected

Description : What is the advantage of AC over DC electrical transmission?

Description : effect of inductance and capacitance on performance of transmission line.

Answer : Following are the effect on performance of transmission line:  1. Due to inductance (L) voltage drop in transmission line produces.  2. Capacitor (C) draws charging current ... , transmission line efficiency, voltage regulation & also power factor of transmission line gets affected. 

Description : While calculating performance of medium transmission line, what assumptions are made in case of (i) Nominal 'T' Method (ii) Nominal 'TT' Method. 

Answer : (i) Assumptions are made in case of Nominal 'T' Method:  a. It is assume that line capacitance is connected at center of transmission line. b. It is assume that half ... assumed that transmission line resistance & reactance per phase is connected in between two half transmission line capacitance 

Description : HVDC transmission line in India: 

Answer : HVDC transmission line in India:  S.N .  From To  Voltage 1 Rihand (U.P) (from 1990) Dadri +- 500 KV (bipolar) 2 Talcher- is the biggest ... (Chandrapur) Western Region  140KV   8 Connecting Southern region(Vizag- Gajuwaka) Eastern Region 140KV 

Description : effect of line parameter on performance of transmission line. 

Answer : Following are the effect of line parameter on performance of transmission line:  1. Due to resistance (R), voltage drop in transmission line & copper losses in transmission line ... transmission line efficiency, voltage regulation & also power factor of transmission line gets affected. 

Description : necessity of transmission of electricity.

Answer :  Because of following points there is necessity of transmission of power:   1. Electrical load on power system is not concentrated at one place but it is widely spread.  2. Load ... to the point of actual utilization of it (consumers) for this purpose transmission electricity is necessary. 

Description : Why is AC better for long distance power transmission than DC ?

Answer : ac is more economical to transmit for long distances . wires can be made smaller by step up transformer .. since major cost are wires to transmit .. then at the end of distance step down transformer is used for commercial use.

Description : Obtain the relationship between the reflection and the transmission coefficients in terms of the intrinsic impedance of the respective mediums when a plane wave propagating normal to the reflection surface  between medium 1 and medium 2 reflects on the inter surface

Description : i) State the significance of modulation index in AM transmission. ii) Explain the effect of modulation index on AM wave with waveforms.

Answer : Significance of modulation index in AM transmission  It is used to determine the strength and quality of transmitted signal. If the modulation index is small, then the amount of variation in ... amplitude part of its information is lost in the process of modulation which is undesirable.

Description : Compare characteristics of asynchronous and synchronous transmission mode (four points). 

Answer : Synchronous transmission Asynchronous transmission 1. Synchronous transmission are synchronized by an external clock. 1. Asynchronous transmission are synchronized by special signals along the transmission ... for transferring a small amount of data as it is simple and economical.

Description : A 50Ω transmission line is terminated in an impedance of 20-j50. What will be the reflection coefficient? A) 0.69 B) 1.69 C) 6.9 D) 16.9 

Answer : A 50Ω transmission line is terminated in an impedance of 20-j50. What will be the reflection coefficient? A) 0.69 B) 1.69 C) 6.9 D) 16.9 

← Prev Question Next Question →
editChoose topic
...