search
person

1 Answer

An efficient and a well designed protective relaying should have good selectivity and reliability, economy and simplicity, high speed and selectivity.

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : The operating point of a protective current transformer is near the

Answer : The operating point of a protective current transformer is near the Ankle point

Answer : Protective relays are devices that detect abnormal conditions in electrical circuits by measuring constantly the electrical quantities which differ during normal and abnormal conditions.

Answer : Burden of a protective relay is the power absorbed by the circuit of relay.

Description : A circuit breaker is designed to protect an electrical circuit from damage caused by :  (A) Over load (B) Short circuit (C) Over current (D) All of the above

Answer : A circuit breaker is designed to protect an electrical circuit from damage caused by :  (A) Over load (B) Short circuit (C) Over current (D) All of the above

Answer : Air blast circuit breakers for 400 kV power system are designed to operate in 50 millisecond.

Answer : Relays can be designed to respond to changes in resistance, reactance or impedance voltage and current, light intensity, temperature.

Description : Why is AC considered more efficient than DC?

Answer : Ac is more efficient than dc because it is easy to maintain and change the voltage of ac for transmission and distribution purpose. Plant cost of ac transmission is much lower compared to dc transmission. When fault occurs it is easy to interrupt ac supply.

Answer : Most efficient plants are normally used as base load plants.

Description : Explain the lighting scheme to be designed for each of the following: i) Special ward in hospitals ii) Dentist’s Cabin 

Answer : i) Special ward in hospital: For the patients in the wards, lighting should create a cozy and pleasant atmosphere. Lighting in the wards should be planned in such a way that it meets the specific ... we use such as cements and bonding agents that we use to restore your teeth back to health.

Description : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be ... Current will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Answer : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be ... will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Answer : D.C. generators are normally designed for maximum efficiency around full-load.

Answer : The efficiency of a properly designed synchronous motor will usually fall in range 85 to 95%.

Answer : Generators for peak load plants are usually designed for maximum efficiency at 50 to 75 percent full load.

Answer : Overhead system can be designed for operation up to 400 kV.

Description : For an efficient and durable learning, learner should have (A) ability to learn only (B) requisite level of motivation only (C) opportunities to learn only (D) desired level of ability and motivation

Answer : (D) desired level of ability and motivation

Description : Zero-sequence current is used for relaying purpose only in the case of   (a) Phase over current relay (b) Phase impedance relay (c) Ground over current relay (d) Ground impedance relay

Answer : Zero-sequence current is used for relaying purpose only in the case of Ground impedance relay

Description : Which of the following qualities is most essential for a teacher? (A) He should be a learned person. (B) He should be a well dressed person. (C) He should have patience. (D) He should be an expert in his subject. 

Answer : (C) He should have patience. 

Description : The most accurate statement about teaching machines is that Options: A) b. f. skinner Began The Movement For Their Use. B) They Were Designed As A Economy Measure To Replace Teachers. C) They Are Not As Efficient As Teachers In Reinforcing Responses D) They Can Be Used For All earning Programmes

Answer : A) b. f. skinner Began The Movement For Their Use. 

Description : Define the following terms with respect to protective relays i) Relay time ii) Reset current iii) Plug setting multiplier and iv) Time setting multiplier

Answer : 1) Relay Time: The time interval between occurrence of fault and closure of relay contacts.  2) Reset Current: The value of current below which the relay resets and comes back to ... The adjustment arrangement provided for setting the operation time of relay is known as Time setting multiplier. 

Description : State four functions of protective system.

Answer : Functions of Protective System:  1) To switch ON or OFF the electric power during normal conditions for operation and maintenance.  2) To protect the power system by isolating the faulty ... major faults.  7) To ensure maximum safety conditions from generation stage to consumers premises.

Description : The burden of protective Current Transformer (CT) is specified in

Answer : The burden of protective Current Transformer (CT) is specified in Volt - Ampere

Description : The first order control system, which is well designed, has a?

Answer : The first order control system, which is well designed, has a large negative transfer function pole.

Answer : The total losses in a well designed D.C. generator of 10 kW will be nearly 500 W.

Description : A fuse wire should have :  (A) Low specific resistance and high melting point (B) Low specific resistance and low melting point (C) High specific resistance and high melting point (D) High specific resistance and low melting point

Answer : A fuse wire should have : High specific resistance and low melting point

Answer : Series reactors should have low resistance.

Description : A single phase transformer is designed to operate from 50 Hz, 1100 V supply and to have an output voltage of 240 V at no load. The core has mean area of 30 cm2 and the flux density has not to exceed 1.3T. The number of secondary turns will be (a) 1270 (b) 1017 (c) 768 (d) 277  

Answer : E2=e2=4.44*flux*N2*f=240 V Flux=Flux density* Area Area=30 cm2  =30*10-4 m2 Flux= 1.3*30*10-4  Wb=39*10-4 Wb E=240= 4.44*39*10-4 *N2*50      N2=277.

Description : The most efficient torque — producing actuating structure for induction — type relay is:

Answer : The most efficient torque — producing actuating structure for induction — type relay is: induction-cup structure

Description : If you have all the potentialities to become an efficient teacher but the school's adverse conditions do not help you. How could you adjust with this reality? Options: A) You will continue ... work unwillingly under these prevailing situations D) You will not even try to think about its solution

Answer : B) You will try force the administrative machinery to control the conditions 

Description : School based assessment is primarily based on the principle that Options: A) teachers know their learners' capabilities better than external examiners B) students should at all costs get high ... schools are more efficient than external bodies of examination D) assessment should be very economical

Answer : A) teachers know their learners’ capabilities better than external examiners 

Description : Right-handed people live, on average, nine years longer than left-handed people do. This doesn't have a genetic basis, but is largely due to the fact that a majority of the machines and ... them somewhat dangerous for lefties to use and resulting in thousands of accidents and deaths each year. 

Description : Approximately 75% of human waste is made of water. While we might typically think that urine is the liquid part of human waste products, the truth is that what we consider solid waste is ... as drier harder stools are what cause constipation and are much harder and sometimes painful to pass.

Description : What Can A Teacher Do To Develop Integrated Personalities Of His Pupil? Options: A) Children Should Be Encouraged And Helped To Set Themselves Well-Defined Goals And Objectives Which They Can Hope To ... Should Be So Planned That Children Are Able To Express Themselves Fully. D) All Of These

Answer : D) All Of These 

Description : In making use of employment information, it is well to remember that Options: A) The more general the information, the more useful it is B) One should select one source of information ... Descriptions in term of absolute adjectives are best D) Recent primary sources are better than secondary ones

Answer : D) Recent primary sources are better than secondary ones 

Description : A good thesis writing should involve: (a) reduction of punctuation and grammatical errors to a minimum. (b) careful checking of references. (c) consistency in the way the thesis is written. (d) a clear and well written abstract. Select ... c) and (d) (C) (a), (b) and (c) (D) (a), (b) and (d)

Answer : Answer: B

Description : The line trap unit employed in carrier current relaying method offers: (A) high impedance to 50 Hz power frequency signal (B) high impedance to carrier frequency signal (C) low impedance to ... signal (D) high impedance to 50 Hz power frequency signal and high impedance to carrier frequency signal

Answer : The line trap unit employed in carrier current relaying method offers: high impedance to carrier frequency signal 

Description : Pilot relaying schemes are used for the protection of   (a) Bus bars (b) Transformer (c) Instrument transformer (d) Transmission line 

Description : Is the filament resistance lower or higher in a 500 watt light bulb than in a 100 watt light? Assume that both bulbs have been designed to operate at 110 volts. 

Answer : ANSWER: LOWER

Answer : Power transformers are generally designed to have maximum efficiency around near full-load.

Description : What are the algorithms to have efficient parsing?

Answer : i. Left to right parsing algorithm  ii. Chart Parsing algorithm.  iii. Left corner parsing

Description : 1. How can Permanent hardness of water be removed? 2. The Sun City is located in which continent? 3. Which situation makes a firm most efficient? 4. On the shore of which counrty cold currents ... Aravalli ranges are an example of which mountains? 20. Which war was ended by the Treaty of Madras?

Answer : Answer : 1. By adding washing soda 2. South Africa3. Lowest average costs 4. Peru 5. Ramananda 6. Hydra 7. Dr. B. R. Ambedkar 8. Black 9. North-west Atlantic10. Gulbadan Begam 11. Bangladesh ... Rana Sanga 16. The Cabinet 17. Radio waves 18. Morarji Desai 19. Residual mountains 20. First Mysore war

Description : Why should care be taken when prescribing warfarin and amiodarone in combination? A. Amiodarone and warfarin both have an anticoagulant effect. B. Amiodarone may reverse the anticoagulant ... anticoagulant effect of warfarin. D. Warfarin may reverse the antiarrhythmic effect of amiodarone.

Answer : C. Amiodarone may increase the anticoagulant effect of warfarin. 

Description : If we believe in the dualistic theory of the mind versus body nature of an, have to arrive at the consequence that Options: A) Education is mechanization in process and theoretical in development B) ... behaviour of man D) Education is purely a matter of mental training and development of the self.

Answer : D) Education is purely a matter of mental training and development of the self. 

Description : When you are invited for a feast, then you have the idea that Options: A) Do wastage of food in order to pay the gift or money on the occasion B) It is an opportunity to take food ... the basis of relations and affinity D) Never waste any food particle whether you are at home or in feast

Answer : C) That families should join such parties on the basis of relations and affinity 

Answer : An instrument to be used for measurement and control should preferably have Linear output and fast response

Description : The burden value in Potential Transformer (PT) should be ______ to achieve low errors in PT: A) low B) high C) medium D) infinite

Answer : The burden value in Potential Transformer (PT) should be high to achieve low errors in PT: 

Description : For selecting a circuit breaker, ______ should be determined.  (A) initial current that flows on occurrence of a short circuit only (B) transient current that flows at the time of circuit interruption only (C) resonant frequency only (D) (A) and (B) 

Answer : For selecting a circuit breaker, ______ should be determined. (A) initial current that flows on occurrence of a short circuit only (B) transient current that flows at the time of circuit interruption only (C) resonant frequency only (D) (A) and (B) 

Answer : The ground wire should not be smaller than No 10 copper.

Answer : In order that current should flow without causing excessive heating or voltage drop, the relay contacts should have low contact resistance, be clean and smooth, be of sufficient size and proper shape.

Description : For an SCR with turn-on time of 5 microsecond, an ideal trigger pulse should have   (a) short rise time with pulse width = 3 µsec (b) long rise time with pulse width = 6 µsec (c) short rise time with pulse width = 6 µsec (d) None of the above 

Answer : a

Answer : Core of an electromagnet should have low coercivity, high susceptibility.

← Prev Question Next Question →
editChoose topic
...