search
person

2 Answers

 Incorrect polarity will result in dead short circuit.

thumb_up_alt 0 like thumb_down_alt 0 dislike
Winding will be damaged
thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : If the percentage impedances of the two transformers working in parallel are different, then?

Answer : If the percentage impedances of the two transformers working in parallel are different, then parallel operation will still be possible, but the power factors at which the two transformers operate will be different from the power factor of the common load.

Answer : Necessary conditions required to be satisfied in order to ensure successful parallel operation of single phase transformers:  1. Only transformers having the same phase displacement between primary and secondary ... . 7. The phase sequence must be followed strictly on HV and LV side connection.

Description : Losses which occur in rotating electric machines and do not occur in transformers are?

Answer : Friction losses windage losses 

Description : Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in?

Answer : Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in loading of the transformers not in proportion to their kVA ratings.

Description : The efficiencies of transformers compared with that of electric motors of the same power are?

Answer : Transformers have high efficiency than the same ratted motors

Description : Two 3-phase transformers cannot be operated in parallel, if their :  (A) kVAs are different (B) phase sequences are different (C) % impedances are different (D) voltage ratios are different

Answer : Two 3-phase transformers cannot be operated in parallel, if their : phase sequences are different

Description : In a transmission line if booster transformers are to be used, preferred location will be  (A) At the receiving end (B) At the sending end (C) At the intermediate point (D) Anywhere in the line 

Answer : In a transmission line if booster transformers are to be used, preferred location will be At the intermediate point

Answer : Power transformers are generally designed to have maximum efficiency around near full-load.

Answer : Distribution transformers are generally designed for maximum efficiency around 50% load.

Answer : Natural oil cooling is used for transformers up to a rating of 3000 kVA.

Answer : Short circuit test on transformers is conducted to determine copper losses.

Answer : Natural air cooling is generally restricted for transformers up to 1.5 MVA .

Description : The efficiency of two identical transformers under load conditions can be determined by?

Answer : The efficiency of two identical transformers under load conditions can be determined by back-to-back test.

Description : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that

Answer : An additional condition for parallel operation of three-phase transformers over single-phase transformers is that the transformers should belong to the same vector group

Description : Two transformers with identical voltage ratings are working in parallel to supply common load. The percentage impedance of one transformer is higher compared to that of other. The load sharing ... respective impedance (4) Depend on the resistance to leakage reactance ratio of each transformer

Answer : Two transformers with identical voltage ratings are working in parallel to supply common load. The percentage impedance of one transformer is higher compared to that of other. The load sharing between the two transformer will: Be inversely proportional of their respective impedance

Description : Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

Answer : Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

Answer : Current transformers (CT) : Current transformer (CT) actually step down the high current to low current for the operation of relays. Current transformer is use for measurement of ... use for relay. This is about potential transformer.

Description : The friction losses in Real Transformers are :  (A) 0% (B) 5% (C) 25% (D) 50%

Answer : A

Description : Core type transformers are popular in___________.  (A) High voltage applications (B) Low voltage applications (C) All of the above (D) None of the above

Answer : Core type transformers are popular in High voltage applications

Answer : Instrument transformers are potential transformers, current transformers.

Description : What is the back EMF in Transformers?

Answer : The capacity of capacitor is added and it becomes multiple of no of capacitors capacity

Description : If two 3-phase transformers with unequal voltage ratios are connected in parallel, the result is (A) circulating current on no-load (B) no circulating current on no-load (C) dead short-circuit (D) equal no-load secondary emfs 

Description : Which of the following is the advantage of using CRGO steel in transformers? A) High magnetic flux density B) Low permeability C) Both A and B D) None of these

Answer : It definitely High Magnetic Flux Density since a crgo steel has always a more around 3% of silicon proportion among the remaining ferrite which make cold rolled grain oriented steel having high flux magnetic ... for more about the crgo core you can learn here https://nicoreindia.com/crgo-core/

Description : Classify the transformers based on the construction, frequency and power.

Answer : Classification of Transformer Based On: i) Construction: Shell type, Core type, Berry type ii) Change in voltage level: Step-Up, Step-Down, iii) Number of phases: Single phase, Three phase iv) ... Control vi) Cooling: Self-cooled, Air-cooled, Forced-air cooled, Oil-cooled, Forced-oil cooled. 

Description : Two transformers A and B having equal outputs and voltage ratios but unequal percentage impedances of 4 and 2 are operating in parallel. The transformer A will be overloaded by 

Answer : Two transformers A and B having equal outputs and voltage ratios but unequal percentage impedances of 4 and 2 are operating in parallel. The transformer A will be overloaded by 33%

Description : Why do transformers make noise?

Answer : Transformers make noise based on it out put if an transformer outputs is 400v maximum than a 398v be apply to that transformer it also make a noise because of that 

Answer : Harmonics in transformer result in increased core losses, increased I2R losses, and magnetic interference with communication circuits.

Answer : A common method of cooling a power transformer is oil cooling.

Description : Two transformers operating in parallel will share the load depending upon their

Answer : Two transformers operating in parallel will share the load depending upon their Per unit impedance

Description : State any two conditions for parallel operation of 3-phase transformer.

Answer : Conditions for Parallel operation of 3 phase transformer 1) Voltage ratings of both the transformers must be identical. 2) Percentage or p.u. impedance should be equal in magnitude. 3) X/R ratio ... between primary & secondary voltages must be same. 6) Phase sequence on both sides must be same.

Description : If a cell connection is reversed in parallel group, what will happen? A. Open circuit B. All cells will be equally charged C. short circuit D. Nothing will happen 

Answer : If a cell connection is reversed in parallel group, what will happen?  Open circuit

Description : What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Answer : What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Description : Two transformers are to be operated in parallel such that they share load in proportion to their kVA ratings. The rating of the first transformer is 500 kVA ratings. The rating of the first transformer is 500 kVA and its pu ... its pu leakage impedance is  (A) 0.20 (B) 0.10 (C) 0.05 (D) 0.025

Answer : Two transformers are to be operated in parallel such that they share load in proportion to their kVA ratings. The rating of the first transformer is 500 kVA ratings. The rating of the first transformer is ... .05 pu. If the rating of second transformer is 250 kVA, its pu leakage impedance is 0.10

Description : What will happen if a voltmeter is connected like an ammeter in series of the load ? (a) The meter will burn out. (b) The measurement will be too high. (c) The same current will flow as would have been with ammeter in circuit. (d) There will be almost no current in the circuit. 

Description : Which of the following will happen if a voltmeter is connected like an ammeter in series to the load ? (A) There will be almost no current in the circuit. (B) The meter will burn. (C) The measurement will be trio high. (D)  A very high current will flow.

Answer : Which of the following will happen if a voltmeter is connected like an ammeter in series to the load ? (A) There will be almost no current in the circuit. (B) The meter will burn. (C) The measurement will be trio high. (D)  A very high current will flow.

Description : When two transformer of different kVA rating are connected in parallel they share the load in proportion to their respective kVA rating only when their:

Answer : When two transformer of different kVA rating are connected in parallel they share the load in proportion to their respective kVA rating only when their: P u impedance are equal

Description : A 20 ohm resistor and a 60 ohm resistor are connected in parallel to a voltage source. If the current in the 60 ohm resistor is one ampere, the current in the 20 ohm resistor will be: w) 1/3 ampere x) 2/3 ampere y) 1 ampere z) 3 amperes

Answer : ANSWER: Z -- 3 AMPERES

Description : Three single phase transformers each with 10 kVA rating are connected in a closed delta arrangement. If one transformer is taken out, the output capacity of the system will be (a) 20 kVA (b) 8.66 kVA (c) 17.32 kVA (d) 10 kVA

Description : Three lamps are connected in parallel across a 120 Volt source. If one lamp burns out, the remaining two will be: A. Glow dimmer B. Glow brighter C. Not light D. Glow with the same brightness as before

Answer : Glow with the same brightness as before 

Description : What would happen if corpus luteum is not degenerated (a) Progesterone will not be secreted (b) Endometrium will disintegrate (c) Proliferation of endometrium will take place (d) Ovulation will take place 

Description : Two transformers having the same p.u. impedance connected in parallel share the connected load (A) equally (B) in proportion to the respective ratings (C) in proportion to the voltage ratio (D) in proportion to the zero phase displacement

Answer : Two transformers having the same p.u. impedance connected in parallel share the connected load in proportion to the respective ratings

Description : what will be the capacitance if three capacitors connected in parallel each having value of 0.5 micro Farad ?

Answer : the total capacitace when connected in parallel Tc=total capacitor c1=c2=c3=0.5uf Tc=c1+c2+c3 Tc=1.5uf

Description : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be ... Current will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Answer : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be ... will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Description : 1. If a ship moves from freshwater into seawater, what will happen? 2. Which was the first National Security Advisor of India who died recently? 3. What is the first compound which is fixed ... year? 20. Which Gupta ruler was equally great in the art of peace, wars and personal accomplishment?

Answer : Answer : 1. It will rise a little higher 2. Brajesh Mishra 3. Glucose 4. Nimbus 5. Bimbisara 6. Goa 7. Mass of the body 8. Oudh Commercial Bank 9. Cumulonimbus 10. Priyadarsi 11. A. Motion ... 15. Madras 16. Hydrogen 17. 21st March, 1996 18. Varada Grameen Bank 19. Tundra Climate 20. Chandragupta-II

Description : If a positively charged body is placed inside a spherical hollow conductor, what will be the polarity of charge inside and outside the hollow conductor ? (a) Inside positive, outside negative (b) Inside negative, outside positive (c) Both negative (d) Both positive

Answer : The polarity of the charge will positive

Description : Define transformation ratio in terms of current and voltage.

Answer : (i) Transformation Ratio (K) is defined as the ratio of the primary current to the secondary current.  (ii) Transformation Ratio (K) is defined as the ratio of the secondary voltage to the primary voltage.

← Prev Question Next Question →
editChoose topic
...