Is electric potential zero when electric field is zero?

1 Answer

Yes  .If  electric  field  is  zero  then  electric  potential  is  zero  ,  not  even  one.
Like 0 like Dislike 0 dislike

Related questions

Description : Can the electric field between two positive charges be zero?

Answer : It  can  only  if  they  have  equal  charges.

Description : Briefly describe the electric field of a static charge.

Description : The ability of materials to become polarized under an applied electric field is called _______ A) Ferroelectricity B) Paraelectricity C) Polectricity D) None of these

Answer : The ability of materials to become polarized under an applied electric field is called Paraelectricity

Description : The electric field inside a hollow conducting sphere ________ A) Depends on the diameter of the sphere  B) Varies according to the direction of earth’s magnetic poles C) Is zero  D) None of these

Answer : The electric field inside a hollow conducting sphere Is zero

Description : What is the direction of the induced electric field?

Answer : It  is  in  opposite  direction   to  the  one  that   produced  it.

Description : What is the direction of the electric field?

Answer : Electric   field    is  at   right angle   widh  flow  of  current  (right  hand   rule).

Description : MOSFET uses the electric field of?

Answer : MOSFET uses the electric field of gate capacitance.

Description : An electric motor in which both stator field and rotor rotates with same speed is called?

Answer : An electric motor in which both stator field and rotor rotates with same speed is called synchronous motor.

Description : How can a magnetic field be used to generate an electric current?

Answer : Magnetic  field  can  be  used  to  generate  electric  current  on  a  condition  that  it  is  on  a  rate  of  changing  magnetic  flux.  (Faraday's  law)

Description : Explain why potential difference is necessary to produce current in a circuit.

Description : What is the potential barrier of metal?

Answer : Potential barrier of metal is zero.

Description : Which of the following has nearly zero temperature coefficient? A) Constantan B) Manganin C) Both A and B D) None of these

Answer : Which of the following has nearly zero temperature coefficient? A) Constantan B) Manganin C) Both A and B D) None of these

Description : The magnetic factor required to reduce the residual magnetization zero is called?

Description : The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%

Answer : The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is 11%

Answer : In a Schering bridge the potential of the detector above earth potential is a few volts only.

Description : ln HRC fuse the time between cut-off and final current zero is called

Answer : ln HRC fuse the time between cut-off and final current zero is called the arcing time

Answer : A transformer can have regulation closer to zero on leading power factor.

Description :  Field intensity formula

Answer :  Field intensity formula

Description : Energy stored in electrostatic field of capacitance formula

Answer : Energy stored in electrostatic field of capacitance formula

Description : What arc the errors occurring in measuring devices due to stray magnetic field and temp '? Explain how to compensate them.

Answer : 1. Error due to stray magnetic fields-   Main magnetic field gets disturbed by external magnetic fields known as stray magnetic fields.  2. Compensation technique   To avoid this error, ... resistance alloy having a negligible resistance temp coefficient in the ratio of 1:10 for pressure coil 

Description : Define junction field effect transistor (JFET) and give an example.

Answer : Junction Field-Effect Transistor: It is a semiconductor device having three terminals, namely Gate, Drain and Source, in which the current flow is controlled by an electric field set up by an external voltage applied ... : i) n-channel JFET and ii) p-channel JFET Examples of JFET: BFW 10, BFW 11 

Description : Derive an expression for energy stored in a magnetic field . 

Answer : Expression for energy stored in a magnetic field: The energy is stored in magnetic field when current increases and return back when the current decreases. At instant t' seconds after closer of switch ... energy absorbed by the magnetic field when current increases from 0 to I amperes 

Description : Give the relation between magnetic field strength, magnetic flux density and permeability.

Description : Define magnetic field strength and state its unit.

Answer : Magnetic field strength is the force experienced by a unit N-pole when placed at any point in a magnetic field is known as magnetic field strength or magnetizing force. Magnetising force or magnetic field ... unit of length is metre. So the unit of magnetic field strength is ampere turns per metre.

Description : Which of the following laws relates the magnetic field to the magnitude, direction, length, and proximity of the electric current? A) Lenz’s law B) Faraday’s law C) Biot–Savart law D) None of these

Answer : Which of the following laws relates the magnetic field to the magnitude, direction, length, and proximity of the electric current? A) Lenz’s law B) Faraday’s law C) Biot–Savart law D) None of these

Description : A constant potential difference is applied across the plates of a parallel-plate capacitor. Neglecting any edge effects, the electric field inside the capacitor is: w) constant x) varying as one over r squared y) decreasing as one moves from the positive to the negative plate z) zero

Answer : ANSWER: W -- CONSTANT

Description : Electric stove. What to look for when choosing?

Answer : Modern electric stoves are presented in such a wide variety that it is very easy for people who are far from technical nuances to get lost in it. The electrical goods market offers both ... be useful to you. And then the purchased device will become your irreplaceable assistant for many years.

Description : When electric current passes through a bucket full of water, lot of bubbling is observed. This suggests that the type of supply is?

Answer : When electric current passes through a bucket full of water, lot of bubbling is observed. This suggests that the type of supply is D.C.

Description : When electric current passes through a metallic conductor, its temperature rises. This is due to?

Answer : When electric current passes through a metallic conductor, its temperature rises. This is due to collisions between conduction electrons and atoms.

Description : Why does the magnetic field flow from north to south?

Description : State advantages of rotating field type alternators. 

Answer : Advantages of Rotating Field Type Alternator: 1) For high-voltage alternator, large space is required to accommodate conductors with insulation, as high voltage is induced in them. If field poles are placed ... is kept rotating. 8) Rotating field is comparatively light and can run with high speed. 

Description : A magnetic circuit has effective iron length of 100 cm and it is wound with 800 turns of wire carries 1 A. Find the magnetic field strength.

Answer : magnetic field strength

Description : In a synchronous machine, if the field flux axis ahead of the armature field axis in the direction of rotation, the machine is operating as  (1) synchronous motor (2) synchronous generator (3) asynchronous motor (4) asynchronous generator

Answer : In a synchronous machine, if the field flux axis ahead of the armature field axis in the direction of rotation, the machine is operating as synchronous generator 

Description : Which of the following statements is not characteristic of a static magnetic field? (A) It is solenoidal. (B) It is conservative. (C) It has no sinks or sources. (D) Flux lines are always closed.

Answer : Which of the following statements is not characteristic of a static magnetic field? (A) It is solenoidal. (B) It is conservative. (C) It has no sinks or sources. (D) Flux lines are always closed.

Description : It is possible to increase the field flux and, at the same time, increase the speed of a d.c. motor provided its .......... is held constant.

Answer : It is possible to increase the field flux and, at the same time, increase the speed of a d.c. motor provided its armature current is held constant.

Description : A field of force can exist only between?

Answer : A field of force can exist only between two ions.

Answer : To avoid the effect of stray magnetic field in A.C. bridges we can use magnetic screening.

Answer : A sinusoidal voltage of 5 Hz is applied to the field of a shunt generator. The armature voltage wave will be of 5 Hz.

Answer : Flashing the field of D.C. generator means creating residual magnetism by a D.C. source.

Answer : Magnetic field in a D.C. generator is produced by electromagnets.

Answer : If a D.C. shunt motor is working at full load and if shunt field circuit suddenly opens this will make armature to take heavy current, possibly burning it.

Answer : If the field of a D.C. shunt motor gets opened while motor is running the motor will attain dangerously high speed.

Answer : In a shaded pole single-phase motor, the revolving field is produced by the use of shading coils.

Answer : If the field winding of an unloaded salient pole synchronous motor is open circuited, the motor will stop.

Description : If the field of synchronous motor is under excited, power factor will be?

Answer : If the field of synchronous motor is under excited, power factor will be lagging.

Description : What do you mean by electromagnetic field?

Description : From which material field coils of DC generator are made of?

Answer : Field coils of DC generator are usually made of copper.

Description : Field control of DC motor

Answer : Field control of DC motor

Description : Select insulating materials for following parts : (i) Insulation between heating element and base plate of electric iron. (ii) Insulation used over copper or aluminium conductor used for making coils. (iii) Transformer bushings. (iv) Insulation between transmission line and pole.

Answer : Parts Insulating Materials  Insulation between heating element and base plate of electric iron. Mica Insulation used over copper or aluminium conductor used for making coils.  ... Transformer bushings Porcelain  Insulation between transmission line and pole. Porcelain

Description : State any Four lE Rules regarding electric safety. 

Answer :  lE Rules regarding electric safety: 1. IE Rule 3 : Authorization 2. IE Rule 29 : Construction and maintenance of electrical supply line and apparatus 3. IE Rule 30: Service line and apparatus on ... 26. IE Rule 60: Test for resistance of insulation 27. IE Rule 61: Connection with earth 

← Prev Question Next Question →
Ask a Question
Choose topic