What is the harmonic filter?

answered
by
Ss

It is being used to supress the input voltage distortion at input side of any electrical equipment. This distortion is created by other electrical loads like motor, drives etc nearby connected with same source. Harmonic filter to be designed for a range of harmonics or specific harmonics like 3rd harmonics 5th harmonics, 7th harmonics.

Welcome to AskOrAnswerMe.com , where you can ask questions and receive answers from other user. Feel free to ask any question. Help everyone by giving best answer to the questions.

11,555 questions

10,176 answers

190 comments

4,088 users

- The second harmonic distortion is defined as the
- What is harmonic in power quality?
- What do you mean by active filter? State its advantages over passive filter . Define pass band & stop band with respect to filter.
- The time period of third harmonic of power supply frequency, in milliseconds, is
- The fractional-pitch used for eliminating 7th harmonic from the emf wave of an alternator is
- What is the function of an electrical filter ?
- What is the convolution filter?
- Which capacitors are suitable for DC filter circuits?
- write short notes on Low-pass filter.
- To get minimum harmonic distortion in the output, a 34 to 34 cyclo-converter requires :
- Explain the sinusoidal harmonic reduction techniques for cylcoconverters.
- need of rectifier and filter.
- State any four advantages of LC filter.
- Compare RC and LC filter.
- Explain design constraint of filter inductor design.
- What is the effect of following on induction motors: (1) Voltage unbalance (2) Harmonic distortion
- Maximum phase distortion is encountered when using the filter approximation...
- A band pass filter is that which
- Prior to sampling an anti-aliasing filter is used.
- Rectification efficiency of a full wave rectifier without filter is nearly equals to:
- A twin T network is a filter of kind...
- For a prototype low pass filter, the series and shunt elements are respectively _____.
- The ripple factor in an LC filter.
- The values of L and C for a low pass filter with cut off frequency of 2.5 KHz and operating with a terminated
- What is the significance of signal conditioner? Explain the need of following in mechatronics system. i) Isolator ii) Filter iii) Amplifier iv) Data converter
- Low pass filter with cut off frequency of 100 kHz and high pass filter with cut off frequency of
- Angles in degrees of pole locations of 4th order Butterworth low pass filter approximation from either...
- Harmonic distortion of the signal is produced in an RC coupled transistor amplifier. The probable
- A square wave has a period of 60 s. The first odd harmonic is:
- The order of the sub-harmonic during SSR for 50 Hz normal frequency is?
- In single pulse modulation of PWM inverters, third harmonic can be eliminated if pulse width is
- Harmonic distortion is due to
- The synchronous speed for the seventh space harmonic mmf wave of a 3-phase, 8-pole, 50 Hz induction
- A high-pass filter has a resistance R = 2 kΩ The lowest input frequency to be passed is 7.5 kHz. The value of
- The shunt element of prototype high pass filter is _____.
- If the filter capacitance is increased, the ripple will
- In a distortion factor meter, the filter at the front end is used suppress
- The output power of a filter is 100 mW, when the signal frequency is 6 kHz. When the frequency is increased...
- The primary function of a filter is to : -
- Define simple harmonic motion. Give its two example.
- A rectangular waveform has fifth harmonic amplitude
- A low-pass filter with a cut-off frequency of 30 Hz is cascaded with a high pass filter with a cut-off frequency
- When measuring strain, ballast circuit use a capacitor to act as a high pass filter. This is done when:
- UNIT 1 THE ATMOSPHERIC FILTER
- State the four advantages of active filter over passive filter.
- Draw the circuit diagram of bridge rectifier with π filter. Draw its input and output waveform.
- What's the function of a band pass filter
- Explain in brief the concept of active and passive filter.
- Where the poles should be placed on the unit circle for stable filter?
- If the output filter capacitor in a power supply actually had a value twice its stated value, which of the

...