# What is an RF Power Meter?

What is an RF Power Meter?

## Related questions

Description : What is a digital power meter?

Description : What is power quality meter?

Description : What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

Answer : What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

Description : List two types of oscillator, which generates frequency in RF range.

Answer : Types of Oscillators generating frequencies in RF range: i) Hartley Oscillator ii) Colpitt’s Oscillator iii) Clapp Oscillator

Description : Explain the “mitigation of power theft” and “faulty meter replacement” for energy conservation techniques to reduce commercial losses.

Answer : Energy conservation techniques to reduce commercial losses:  1. Mitigation of Power Theft: Power theft being the most important issue which all of the service providing utilities ... agricultural sector. Prepaid meters may prove effective measures against unauthorized abstraction of energy.

Description : With a neat sketch explain working of 1 phase dynamometer type power factor meter.

Answer : Working of 1 phase dynamometer type power factor meter : The current coil is connected in series with load. Two pressure coils marked as A and B are connected across the supply terminals ... becomes stationary and the pointer shows steady deflection corresponding to the power factor of the load.

Answer : In a dynamometer 3-phase power factor meter, the planes of the two moving coils are at 120°.

Answer : In a single phase power factor meter the phase difference between the currents in the two pressure coils is exactly 90°.

Answer : The two pressure coils of a single phase power factor meter have the same dimensions and the same number of turns.

Answer : A power factor meter has one current circuit and two pressure circuits.

Description : What does an electric meter measure?

Description : How do you read a KWH Meter?

Description : An induction type energy meter is found to run fast. Correction for this error can be made by  (A) Over-load compensation. (B) Voltage compensation. (C) Moving the brake magnet away from the centre of the disc. (D) Moving the brake magnet towards the centre of the disc.

Answer : An induction type energy meter is found to run fast. Correction for this error can be made by Moving the brake magnet away from the centre of the disc.

Answer : The adjustment of position of shading bands, in an energy meter is done to provide friction compensation.

Answer : An induction meter can handle current up to 100 A.

Description : What is meant by energy meter constant?

Answer : Energy Meter Constant  A fixed value which is used when converting meter readings to actual energy use, especially when potential transformers and similar types of equipment are used in metering. For example, K=--------rev/Kwh

Description : What type of meter is used to measure current?

Answer : Nanometer is a ametric measure of distance equivalent to one billionth of a meter.

Description : What is the use of power factor correction?

Description : What is the best power factor?

Answer : It is unity power factor but difficult to achieve in dynamic loads

Description : What is power factor angle?

Description : What causes random power outages?

Description : What is the advantage of high power factor?

Answer : Reduced copper losses Smaller conductor size Improve voltage regulation Increase system capability Less energy bill

Description : What is power logger?

Description : What are the power quality disturbance?

Description : What is harmonic in power quality?

Description : What is a power quality analyzer?

Description : What are the different power quality issues?

Description : What is good power quality?

Description : What is power quality monitoring?

Description : What can you do to prevent a power surge?

Description : What would cause a power surge in a house?

Answer : If your neibour / other flat owners / your maintainer staff switch on any type of inductive load that can cause power surge / dip

Description : What is meant by power dip?

Description : Draw venture meter and write steps to measure flow rate.

Answer : Venturi meter consists of three sections that is converging section, throat section and diverging section. The flow is introduced to the meter through the inlet with diameter D' . The inclined angle ... to 15o . Flow rate is proportional to the square root of the differential pressure.

Description : List variable flow meter.

Answer : 1. Variable area : Rotameter 2. Variable head : a) Venturi b) Orifice c) Pitot tube d) Nozzle

Description : working of distortion factor meter with block diagram

Answer : Working : Initially the switch S is kept at position 1.The attenuator gets excluded and the bridge T network is adjusted for full suppression of fundamental frequency and hence we get ... is obtained on the meter.Thus the total rms distortion is indicated by the reading of attenuator.

Description : Principal of digital frequency meter.

Answer : The basic block diagram of basic digital frequency meter (DFM) is shown in above figure. The signal whose frequency we have to be measured is first to be amplified through amplifier. The output of amplifier ... = Number of counts. t = Time interval between start and stop condition of the gate.

Description : State one application of clip on meter.

Answer : Clip-on meter is used to measure the High value AC current without breaking the circuit Or without opening the circuit.

Answer : Advantage: Provides wide linear range. 2) Ability to measure reverses flow. 3) Gives rapid response to flow changes. 4) No obstruction is created to flow. 5) It can handle corrosive as ... and pipe networks with relatively short inside diameters. 3) It is useful for electrically conducting fluid.

Description : Compare variable head flow meter with variable area flow meter.

Answer : Parameter Variable head flowmeter Variable area flowmeter Working principle Restriction or obstacle is placed in the path of flow to create a differential Pressure. The pressure ... viscous fluid slurries and dirty fluids. In laboratories and testing and production lines.

Description : Describe principle of operation of Doppler type ultrasonic flow meter with diagram.

Answer : Diagram: Working:  The flow meter consists of a crystal transducer mounted outside the pipe in which flow is to be measured. This transducer is a piezoelectric crystal which ... , so the frequency of the reflected wave is shifted to particle velocity, according to Doppler principle.

Description : Draw the diagram and explain the working of ferrodynamic type frequency meter.

Answer : Ferrodynamic type frequency meter: (Electrical resonance type frequency meter): It consists of a fixed coil. The supply whose frequency is to be measured is connected across it. This coil ... so selected that the moving coil takes up a convenient position when frequency is of normal value.

Description : Draw a block diagram of electronic energy meter. Write function of each block.

Answer : Electronic Energymeter  Functions of components/blocks: - CT reduces current to reasonable value for current scaling network. - Voltage & current scaling networks reduce proportionally the voltage ... ADC converts the square wave frequency analog output to display the energy in watthour.

Description : State the function and shape of following parts used in induction type energy meter: i) Series magnet ii) Shunt magnet iii) Al disc iv) Brake magnet

Answer : i) Series magnet: produce flux proportional to current (load current) of circuit and interact in the aluminum disc with flux produced by voltage magnet for torque production. Its shape is like letter U.  ii) ... : brakes the motion of the aluminum disc or slows it down. Its shape is like letter C.

Description : Write the working of L-C-R meter with suitable sketch.

Answer : LCR meter: A LCR meter (Inductance L, Capacitance C, and Resistance R) test equipment used to measure the inductance, capacitance and, resistance of a component. It works on the principle ... relative change in magnitude of the repetitive variations of the voltage and current known as amplitudes.

Description : State the meaning of creeping error in 1 phase energy meter.

Answer : Creeping error: It is defined as the slow and continuous rotation of the disc of the energy-meter when only pressure coil is energized with no current in the current coil (load current = 0). ... magnet on this iron wire is sufficient to prevent continues rotation of the disc on no load condition.

Description : State the use of shunt and series resistance used in extension of meter.

Answer : Use of shunt and series resistance: i) Use of shunt: To extend the range of Ammeter. ii) Use of series resistance: To extend the range of Voltmeter.

Description : Draw a neat sketch of 1-ph induction type energy meter and write operating principle of it.

Answer : Operating Principal:- The disc is placed between the two-flux due to pressure coil and flux due to current coil, which will set up torque on the disc which is proportional to power causing the ... is proportional to voltage, the second carries a current coil so its flux is proportional to current.

Description : Draw and describe working of electronic energy meter.

Answer : working of electronic energy meter:- 1. CT reduces current to reasonable value for current scaling network. 2. Voltage & current scaling networks reduce proportionally the voltage & ... The ADC converts the square wave frequency analog output to display the energy in watthour.

Description : Describe with working of LCR meter for measurement of inductance.

Answer : working of LCR:- A LCR meter (Inductance (L), Capacitance (C), and Resistance (R) test equipment used to measure the inductance, capacitance and, resistance of a component. It works on the ... in parallel (as would be encountered in measuring a capacitor with a leaky dielectric) [Q setting ]

← Prev Question Next Question →