What is the maximum number of circuit breakers in a panel?

1 Answer

It depends on that which type of panel is this.
Like 0 like Dislike 0 dislike

Related questions

Answer : Air blast circuit breakers for 400 kV power system are designed to operate in 50 millisecond.

Answer : The time of closing the cycle, in modern circuit breakers is 0.003 sec.

Description : The current zero interruption, in oil and air blast circuit breakers, is achieved by?

Answer : The current zero interruption, in oil and air blast circuit breakers, is achieved by lengthening of the gap, cooling and blast effect.

Description : Which of the following circuit breakers has high reliability & minimum maintenance?  (A) Bulk oil type CB (B) Air blast CB (C) Vacuum CB (D) Sulphur hexafluoride CB 

Answer : Which of the following circuit breakers has high reliability & minimum maintenance?  (A) Bulk oil type CB (B) Air blast CB (C) Vacuum CB (D) Sulphur hexafluoride CB 

Description : The following is/are the characteristics of SF6 circuit breakers:  (A) It does not need an auxiliary breaking chamber (B) Short break time of 2 to 2.5 cycles (C) All of the above (D) None of the above

Answer : The following is/are the characteristics of SF6 circuit breakers:  (A) It does not need an auxiliary breaking chamber (B) Short break time of 2 to 2.5 cycles (C) All of the above (D) None of the above

Description : Magnetic circuit breakers use _________ A) Permanent magnets B) Earth magnets C) Solenoid D) All the above

Answer : Magnetic circuit breakers use Solenoid 

Answer : Circuit breakers are essentially current carrying contacts called electrodes.

Answer : Circuit breakers usually operate under transient state of short-circuit current.

Description : In which fault the maximum short circuit current occurs?

Answer : In three phase bolted fault the maximum short circuit occurs.

Description : State maximum power transfer theorem for DC circuit.

Answer : Maximum power transfer theorem for DC circuit: The maximum power transfer theorem states that the source or a network transfers maximum power to load only when the load resistance is equal ... removed (disconnected) ii) All internal independent sources are replaced by their internal resistances.

Description : Panel interview questions

Answer : This post includes panel interview questions and answers, interview tips and how to face panel interview. In a Panel Interview or Committee interview, there are several interviewers raising questions to a ... the company and the job and keep your proper gesture until you have left the company.

Description : List any four measure knobs on front panel on CRO.

Answer : Knobs on front panel of CRO: 1. Power ON- OFF 2. Intensity control 3. Focus control 4. Astigmatism control 5. Volt/Div control 6. Vertical position control 7. Invert 8. Horizontal position control 9. Synchronization. 10. Channel selection.

Description : What is the choice of size and number of generator units in interconnected power system?

Answer : Choice of Size and Number of Generating Units: 1. The size/rating and number of generating units in such way that they approximately match with the load curve as closely as possible. 2. In ... , if power plant is connected to grid system then generating unit of higher capacity can be installed.

Description : What are the number of valence electrons of atoms in semiconductor?

Answer : There are four valence electrons in the atom of a semiconductor.

Description : What is the Gray code word for the binary number 101011?  (1) 101011 (2) 110101 (3) 011111 (4) 111110

Answer : What is the Gray code word for the binary number 101011?  (1) 101011 (2) 110101 (3) 011111 (4) 111110

Description : Why do you need a closed circuit for electricity to flow?

Answer : When  the  circuit  is  closed  , a potential  diffrence  is  realized  between  the  two  nodes  connected  .This  causes  flow of  electrons  and  convection  current.

Description : What is the maximum value of torque angle in synchronous motor?

Answer : The maximum value of torque angle in synchronous motor is 90 degrees electrical.

Description : What is the maximum value of power factor?

Answer : 1 is the maximum value of power factor.

Description : Then number of T-states of the instruction STA in 8085 microprocessor is A) 10 B) 12 C) 13 D) 16 

Answer : Then number of T-states of the instruction STA in 8085 microprocessor is 13 

Description : The number of terminals present in IGBT is A) 2 B) 3 C) 4 D) 5

Answer : The number of terminals present in IGBT is 3

Description : The number of electrons in the outer most orbit of carbon atom is?

Answer : The number of electrons in the outer most orbit of carbon atom is 4.

Description : A number of forces acting at a point will be in equilibrium if?

Answer : A number of forces acting at a point will be in equilibrium if sum of resolved parts in any two per-pendicular directions are both zero.

Answer : The number of brushes in a commutator depends on amount of current to be collected.

Answer : In lap winding, the number of brushes is always same as the number of poles.

Description :  The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be A) 3 B) 2 C) 4 D) 5 

Answer :  The number of loop equations required to completely analysing a network comprising of 8 independent branches and 6 nodes including the reference node shall be 3 

Description :  A connected graph has ‘5’ number of branches and ‘4’ number of nodes. It's rank is A) 1 B) 2 C) 3 D) 4 

Answer :  A connected graph has ‘5’ number of branches and ‘4’ number of nodes. It's rank is 3 

Description : Increasing the number of turns of wire on the secondary of a transformer will  (A) Decrease the secondary current (B) Increase the primary current (C) Have no effect on the secondary current (D) Increase the secondary current

Answer : Increasing the number of turns of wire on the secondary of a transformer will Decrease the secondary current 

Description : The number of poles of 8/6 stepper motor can be :

Answer : The number of poles of 8/6 stepper motor can be : 4

Description : lt the length, number of turns and area of a coil are  doubled, the inductance of the coil

Answer : lt the length, number of turns and area of a coil are  doubled, the inductance of the coil is quadrupled

Description : The number of independent equations to solve a network is equal to?

Answer : The number of independent equations to solve a network is equal to the number of chords.

Description : Build using minimum number of CMOS gates. Three input NAND gate. Two input NOR gate Three input NOR gate Two input AND gate Two input OR gate

Answer : Three input NAND gate. Two input NOR gate Three input NOR gate Two input AND gate Two input OR gate

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Answer : In a D.C. shunt motor, under the conditions of maximum power, the current in the armature will be more than full-load current.

Answer : In repulsion motor, maximum torque is developed when brush axis is at 45° electrical to the field axis.

Answer : In a power plant if the maximum demand on the plant is equal to the plant capacity, then plant reserve capacity will be zero.

Description : If a transformer is continuously operated the maximum temperature rise will occur in?

Answer : If a transformer is continuously operated the maximum temperature rise will occur in windings.

Description : Define : i) Maximum Value ii) RMS Value of ac supply

Answer : i) Maximum Value :- The maximum or peak value attained by an alternating quantity during positive or negative half cycle, is called maximum value or peak value.  ii) RMS Value of ac ... as produced by the alternating current when flowing through the same resistance and for the same time. 

Description : Define the following terms: 1) Virtual height 2) Actual height 3) Critical frequency. 4) Maximum usable frequency.

Answer : 1) Virtual height:- The incident and refracted rays follow paths that are exactly the same as they have been if reflection had taken place from a surface located at a greater height, called ... angle of incidence is other than the normal is known as maximum unstable frequency. MUF= fc secθ 

Description : Maximum Power Transfer Theorem 1

Answer : Maximum Power Transfer Theorem 1

Description : A certain power MOSFET has a maximum junction temperature specification of 1500o C, a junction-to-case thermal resistance of 1.00 C/W, and a junction-to ambient thermal resistance of 600 C/W. If the ambient temperature is 300o C ... the device will be A) 1.52 W B) 1.72 W C) 1.92W D) 2.00 W

Answer : A certain power MOSFET has a maximum junction temperature specification of 1500o C, a junction-to-case thermal resistance of 1.00 C/W, and a junction-to ambient thermal resistance of  ... 300o C, then the maximum allowable power dissipation in the device will be 2.00 W 

Description : The maximum reluctance power of a salient-pole synchronous motor having direct-axis reactance, 1.0 pu and quadrature-axis reactance, 0.5 pu, and input voltage, 1.0 pu is (A) 0.25 pu (B) 0.5 pu (C) 1.0 pu (D) 1.5 pu

Answer : The maximum reluctance power of a salient-pole synchronous motor having direct-axis reactance, 1.0 pu and quadrature-axis reactance, 0.5 pu, and input voltage, 1.0 pu is 0.5 pu

Description : The maximum torque of d.c. motors is limited by?

Answer : The maximum torque of d.c. motors is limited by commutation.

Description : For maximum transfer of power, internal resistance of the source should be?

Answer : For maximum transfer of power, internal resistance of the source should be equal to load resistance.

Description : "Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with?

Answer : "Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen from the terminals of the load". The above statement is associated with Maximum power transfer theorem.

Answer : Series motor has got maximum self relieving property.

Answer : D.C. generators are normally designed for maximum efficiency around full-load.

Answer : The condition for maximum efficiency for a D.C. generator is variable losses equal to constant losses.

Answer : The mechanical power developed by a shunt motor will be maximum when the ratio of back e.m.f. to applied voltage is 0.5.

Description : The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as?

Answer : The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as pull-in torque.

← Prev Question Next Question →
Ask a Question
Choose topic