search
person

How many volts are in the power lines?

Related questions

Description : How many volts does it take to power an Arduino?

Answer : 5volts is enough to supply the Arduino.

Answer : Overhead lines for power supply to tramcars are at a minimum height of 10 m.

Description : In tuned power lines, on load :  (A) the receiving end voltage is numerically equal to the sending end voltage  (B) the receiving end current is numerically equal to the sending end current  (C) there is no voltage drop  (D) all the above

Answer : In tuned power lines, on load :  (A) the receiving end voltage is numerically equal to the sending end voltage  (B) the receiving end current is numerically equal to the sending end current  (C) there is no voltage drop  (D) all the above

Description : State the effects of low power factor on efficiency and voltage regulation of short transmission lines. 

Answer : i) Effect of Low power factor on efficiency:- When power factor of load reduces current drawn by transmission line increases so copper losses in transmission line increases, hence transmission ... increases, so voltage drop in transmission line increases so regulation increases. (Become Poor) 

Description : Why don't we burry power lines underground ?

Answer : Because conductor used for power transmission are not insulated and if we do so it create phase to ground fault causing interruptions to supply.

Description : What is a safe distance from power lines?

Description : how can we express 0.40 kV in volts?

Answer : Kvx1000=400v

Description : If a 5-bus test system contains 6 transmission lines and one transformer, how many non-zero elements are there in the system Y-bus ? (A) 25 (B) 12 (C) 11 (D) 19

Answer : If a 5-bus test system contains 6 transmission lines and one transformer, 19 non-zero elements are there in the system Y-bus.

Description : Why are overhead transmission lines not insulated?

Answer : Insulators are useful to help separate electrical conductors when they come into physical contact. Overhead Transmission Lines Are Not Insulated: The overhead transmission line is carrying extreme high voltage and ... a whole lot of thick insulation to absorb the heat produced by such high voltage.

Description : A minimum clearance of 6.3 m to ground is required for overhead lines when operating voltages are :  (A) less than 66 kV (B) lie between 66 kV and 110 kV (C) more than 165 kV (D) lie between 110 kV and 165 kV

Answer : A minimum clearance of 6.3 m to ground is required for overhead lines when operating voltages are : lie between 66 kV and 110 kV

Answer : Series capacitors on transmission lines are of little use when the load VAR requirement is small.

Description : Find out number of data lines required to interface 16 LEDs arrange in the 4 x 4 matrix form.

Answer : 4+4=8, eight lines are required for 4x4 matrix of 16 LEDs

Description : In which of the following transmission lines, the value of the Shunt admittance should be approximated to zero ? (A) A 66 kV 35 km long line (B) A 132 kV 200 km long line (C) A 220 kV 300 km long line (D) A 400 kV 500 km long line

Answer : In which of the following transmission lines, the value of the Shunt admittance should be approximated to zero ? (A) A 66 kV 35 km long line (B) A 132 kV 200 km long line (C) A 220 kV 300 km long line (D) A 400 kV 500 km long line

Description : The purpose of guard ring in transmission lines is to  (1) reduce the earth capacitance of the lowest unit. (2) increase the earth capacitance of the lowest unit. (3) reduce the transmission lines losses. (4) reduce the reactance of the line

Answer : The purpose of guard ring in transmission lines is to reduce the earth capacitance of the lowest unit.

Description : Corona loss in transmission lines can be reduced by (A) using small diameter conductors (B) using bundled conductors (C) using less spacing between conductors (D) increasing the transmission line voltage

Answer : Corona loss in transmission lines can be reduced by using bundled conductors

Description : State the classification of transmission lines depending on length of transmission lines. 

Answer : A) According to Voltage level: ( 2 Marks)  a) High voltage Transmission Line (HV) up to 33 KV  b) Extra High Voltage Transmission Line (EHV) above 33 KV up to 400 KV  c) Ultra ... Transmission Line: - The length of Long transmission Line is above 200KM and its line voltage is above 100KV

Description : Define magnetic lines of force. Also draw and show magnetic lines of force of a bar type magnet.

Answer : Magnetic Lines of force- These are the imaginary lines (having no physical existence) introduced by Faraday for the pictorial representation of the distribution of a magnetic field.  OR  A line of ... that the tangent at any point gives direction of the resultant force at that point. 

Description : Define magnetic lines of force. Show the magnetic lines of force for bar type magnet.

Answer : Magnetic linens of force is the imaginary lines for magnetic field of magnet around it. These magnetic lines of forces are introduced by Michael Faraday. The direction of lines of force is from N-pole to S-pole. The figure shows lines of force for bar type magnet.

Description : Which of the following is the name given to the lines of electric force which move so that its beginning traces a closed curve on a positive surface and its end traces a corresponding closed curve on the negative surface? A) Tube of surface B) Tube of lines C) Tube of force D) Tube of electricity

Answer : Which of the following is the name given to the lines of electric force which move so that its beginning traces a closed curve on a positive surface and its end traces a corresponding closed curve on the negative ... A) Tube of surface B) Tube of lines C) Tube of force D) Tube of electricity

Description : Why ACSR conductor is used for overhead lines?

Answer : It has high tensile strength 

Description : How does electricity get from the power plant to your home?

Answer : Electricity  gets  into   my   home  due  to  potential  diffrence  created   between  the  live   wire  and  neutral  wire.

Description : What are interconnected power system?

Answer : Interconnected power systems are those which connect different geographic regions. In Australia we have a National Electricity Grid which connects 6 states. Transfers of power occur between the states depending ... make more profit from this.National-Electricity-Market-Fact-Sheet.pdf (0,9 MB)

Description : What are the components of a power system?

Answer : generator Traansformer Conductors Insulators

Description : What is sag in power system?

Answer : Sag is a catenary curve in between two points of supporters.and also we can say the lowest point of the conductor in between the two points of supporters. 

Description : What is meant by feeder in power system?

Answer : A feeder line is a peripheral route or branch in a network which connects smaller or more remote nodes with a route or branch carrying heavier traffic. The term is applicable to any system based on a hierarchical network.

Description : What is microgrid in power system?

Description : What is power system planning?

Description : The constant potential difference across a 2 ohm resistor is 20 volts. How many watts of power are dissipated by this resistor?

Answer : ANSWER: 200 WATTS

Description : How many watts does a power plant produce?

Description : The potential difference across a 4 ohm resistor is 20 volts. Assuming that all of the energy dissipated by this resistor is in the form of heat, how many joules of heat are radiated in 10 seconds?  

Answer : ANSWER: 1000 JOULES

Description : If 10 joules of energy are required to move 5 coulombs of charge between two points, the potential difference between the two points is equal to how many volts?

Answer : ANSWER: 2 VOLTS

Description : How many amps do you need for a house?

Description : How do you find power in a circuit?

Answer : Power can be find in a circuit by the means of meters .if an individual want to check for a power in a circuit he/she Calabria the meters on a high voltage range and put the meters Lee in parallel with the circuit he /she will know the amount of power within that circuit .

Description : How does a turbocharger increase engine power?

Answer : How does a turbocharger increase engine power? The engine of a car, when driving uphill or traveling at high speed on the highway, experiences about the same as a runner at the end ... of compressed air also improves the combustion process, which positively affects the performance of the engine.

Description : Briefly explain how the power factor of an inductive circuit can be improved.

Answer : As we know that power factor should be corrected to ensure that the current supplied is cost friendly. Meaning the power factor should be around one but not greater than one(0.8-0.9) in a ... an inductive circuit due to the inductive reactance which oppose the change of current in the ac circuit. 

Description : Discuss how power factor tariff results into energy conservation.

Answer : Power factor tariff results into energy conservation: i) Applying incentives and penalties according to power factor is an effective way, which enables consumer to improve power factor so that he can ... finally leads to reduction in the current drawn by the load and helps for energy conservation.

Description : How can we improve power factor using synchronous motor?

Description : How much electricity is produced by a power plant?

Description : How can power loss be reduced?

Description : How do you calculate power loss?

Description : How much power does an Arduino use?

Description : How do you power an Arduino?

Description : How do you measure power factor?

Answer : P= 1.83*V*I*[email protected] where P is power           V is voltage            I is current           COS @ is P.F [email protected]= P/(1.83*V*I)  in other way cos @ = true power/apparent power

Description : How often do power surges occur?

Description : How to make power bank from laptop battery cells?

Answer : You can make the power bank from laptop battery cells. Things you need to make power bank from laptop battery cells: Laptop battery cells (about 6 in parallel) Universal Dual USB 5V 1A 2.1A New Hot ... If you have any doubt ask it. Thanks...

Description : How does a capacitor improve power factor?

Answer : Every circuit are usually more inductive than capacitive.it means that the current lags by voltage at small angle.hence we have to compensate this situation so we use Capacitor then this lag is compensate ... angle becomes low and the value of cos(phase angle) is increase and hence power also max.

Answer : By applying various power quality monitoring devices and using telecommunication technique .

Description : An intersection is a point where two or more lines/curves meet or cross. How many intersections are there in the figure given below? 

Answer : 17

Answer : Because of following advantages concentrating type collector are used in solar power plant: -  1. Temperature: Temperature obtained is high because absorber area is less and collector/reflector area ... results: As tracking system is used better results are obtain than flat type collector.

← Prev Question Next Question →
editAsk a Question
...