menu search
person
What is microgrid in power system?
thumb_up_alt 0 like thumb_down_alt 0 dislike
90 views

Related questions

Description :

What is sag in power system?

Answer :

Sag is a catenary curve in between two points of supporters.and also we can say the lowest point of the conductor in between the two points of supporters. 

thumb_up_alt 0 like thumb_down_alt 0 dislike
151 views 2 answers
Description :

What is meant by feeder in power system?

Answer :

A feeder line is a peripheral route or branch in a network which connects smaller or more remote nodes with a route or branch carrying heavier traffic. The term is applicable to any system based on a hierarchical network.

thumb_up_alt 0 like thumb_down_alt 0 dislike
87 views 1 answer
Description :

What are interconnected power system?

Answer :

Interconnected power systems are those which connect different geographic regions. In Australia we have a National Electricity Grid which connects 6 states. Transfers of power occur between the states depending ... make more profit from this.National-Electricity-Market-Fact-Sheet.pdf (0,9 MB)

thumb_up_alt 0 like thumb_down_alt 0 dislike
245 views 3 answers
Description :

What are the components of a power system?

Answer :

generator Traansformer Conductors Insulators

thumb_up_alt 0 like thumb_down_alt 0 dislike
83 views 1 answer
Description :

What is power system planning?

thumb_up_alt 0 like thumb_down_alt 0 dislike
77 views 0 answers
Description :

What is the choice of size and number of generator units in interconnected power system?

Answer :

Choice of Size and Number of Generating Units: 1. The size/rating and number of generating units in such way that they approximately match with the load curve as closely as possible. 2. In ... , if power plant is connected to grid system then generating unit of higher capacity can be installed.

thumb_up_alt 0 like thumb_down_alt 0 dislike
70 views 1 answer
Description :

Explain starting system in diesel electric power plant.

Answer :

Starting system in Diesel Electric Power Plant: It includes Storage battery, compressed air tanks, self-starter etc. The purpose of engine starting system is to rotate the engine initially while ... as Ammeters, Voltmeters, Wattmeters, Thermometers, Pressure gauges, Visible and audible alarm etc.

thumb_up_alt 0 like thumb_down_alt 0 dislike
52 views 1 answer
Description :

Explain fuel system and air intake system in diesel electric power plant.

Answer :

Fuel system and air intake system in diesel electric power plant :  Fuel system: It consists of storage tank, strainers, fuel transfer pump and all day fuel tank. The fuel oil is supplied ... Filters are provided to remove dust particles from air which may act as abrasive in the engine cylinder.

thumb_up_alt 0 like thumb_down_alt 0 dislike
49 views 1 answer
Description :

Generally in a power system network, the load is represented as a :  (A) Constant power in both load flow study and in stability study  (B) Constant power in load flow study and constant impedance in stability study  (C) Constant power in stability study and constant impedance in load flow study  (D) Constant impedance in both load flow study and in stability study

Answer :

Generally in a power system network, the load is represented as a : Constant power in load flow study and constant impedance in stability study 

thumb_up_alt 0 like thumb_down_alt 0 dislike
88 views 1 answer
Description :

A lightening arrester connected between the line and earth in a power system  (1) protects the terminal equipment against travelling surges (2) protects the transmission line against direct lightening strokes (3) suppresses high frequency oscillations in the line (4) reflects back the travelling wave approaching it

Answer :

A lightening arrester connected between the line and earth in a power system protects the terminal equipment against travelling surges

thumb_up_alt 0 like thumb_down_alt 0 dislike
88 views 1 answer
Description :

In voltage source converter based HVDC transmission system the active power is controlled by changing (A) phase angle of the converter ac input voltage (B) supply frequency of the converter ac input voltage (C) magnitude of the converter ac input voltage (D) DC voltage at the inverter terminals

Answer :

In voltage source converter based HVDC transmission system the active power is controlled by changing phase angle of the converter ac input voltage

thumb_up_alt 0 like thumb_down_alt 0 dislike
112 views 1 answer
Description :

The benefit of power factor correction in a power system is (A) lower power consumption (B) increased demand charge (C) reduced load carrying capabilities in existing lines (D) reduced voltage profile

Answer :

The benefit of power factor correction in a power system is lower power consumption

thumb_up_alt 0 like thumb_down_alt 0 dislike
77 views 1 answer
Description :

Answer :

Commonly used instruments in power system measurement are induction.

thumb_up_alt 0 like thumb_down_alt 0 dislike
82 views 1 answer
Description :

Answer :

In a distribution system, in order to improve power factor, the synchronous capacitors are installed at the receiving end.

thumb_up_alt 0 like thumb_down_alt 0 dislike
123 views 1 answer
Description :

Answer :

Air blast circuit breakers for 400 kV power system are designed to operate in 50 millisecond.

thumb_up_alt 0 like thumb_down_alt 0 dislike
190 views 1 answer
Description :

Answer :

The contacts of high voltage switches used in power system are submerged in oil. The main purpose of the oil is to extinguish the arc.

thumb_up_alt 0 like thumb_down_alt 0 dislike
153 views 1 answer
Description :

Summerise the role of power system engineer.

Answer :

Role of power system engineer:  i. On the planning side he or she has to make decisions on how much electricity to generate  ii. For operation of the power system he has to plan for ... for energy conservation and load management. viii. For solving the power system problems he has to update with

thumb_up_alt 0 like thumb_down_alt 0 dislike
52 views 1 answer
Description :

State the functions of fuel system and exhaust system of a diesel power station.

Answer :

Fuel system: It supplies fuel to engine for combustion purpose. It consists of Fuel Pump: - It supplies fuel to engine for combustion purpose. Strainer: - Are provided to remove suspended impurities and ... most of the noise. Chimney:- To exhaust gases in the atmosphere as high as possible. 

thumb_up_alt 0 like thumb_down_alt 0 dislike
51 views 1 answer
Description :

The stability of the power system is not affected by  (1) generator reactance (2) line reactance (3) line losses (4) output torque

Answer :

The stability of the power system is not affected by line losses

thumb_up_alt 0 like thumb_down_alt 0 dislike
268 views 1 answer
Description :

If non-linear loads are connected to the power system, then (A) displacement power factor is same as the total power factor (B) displacement power factor is not equal to the total power factor (C) displacement power factor is due to harmonic currents (D) total power factor is due to fundamental component of current

Answer :

If non-linear loads are connected to the power system, then displacement power factor is not equal to the total power factor

thumb_up_alt 0 like thumb_down_alt 0 dislike
89 views 1 answer
Description :

steady-state stability of a power system is improved by

Answer :

steady-state stability of a power system is improved by using double circuit line instead of single circuit line

thumb_up_alt 0 like thumb_down_alt 0 dislike
287 views 1 answer
Description :

For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is

Answer :

For a 15-bus power system with 3 voltage controlled buses, the size of Jacobian matrix is 25 x 25

thumb_up_alt 0 like thumb_down_alt 0 dislike
2.1k views 1 answer
Description :

With fault clearing time, the transient stability of a power system

Answer :

With fault clearing time, the transient stability of a power system decreases

thumb_up_alt 0 like thumb_down_alt 0 dislike
105 views 1 answer
Description :

Power factor of the system is kept high?

Answer :

Power factor of the system is kept high to reduce line losses, to maximise the utilization of the capacities of generators, lines and transformers, to reduce voltage regulation of the line.

thumb_up_alt 0 like thumb_down_alt 0 dislike
98 views 1 answer
Description :

Answer :

The primary reason for low power factor is supply system is due to installation of induction motors.

thumb_up_alt 0 like thumb_down_alt 0 dislike
98 views 1 answer
Description :

Answer :

The steady state stability of the power system can be increased by connecting lines in parallel.

thumb_up_alt 0 like thumb_down_alt 0 dislike
103 views 1 answer
Description :

Explain power system analysis.

thumb_up_alt 0 like thumb_down_alt 0 dislike
66 views 0 answers
thumb_up_alt 0 like thumb_down_alt 0 dislike
64 views 0 answers
Description :

What are the advantages of an interconnected system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
75 views 0 answers
Description :

What is the definition of an electrical system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
56 views 0 answers
Description :

How many volts are in the power lines?

thumb_up_alt 0 like thumb_down_alt 0 dislike
81 views 0 answers
Description :

How does electricity get from the power plant to your home?

Answer :

Electricity  gets  into   my   home  due  to  potential  diffrence  created   between  the  live   wire  and  neutral  wire.

thumb_up_alt 0 like thumb_down_alt 0 dislike
98 views 1 answer
Description :

What are advantages and disadvantages of Mechatronics system? 

Answer :

Advantages of Mechatronics system:  High level of integration.  Increased functionality and better design.  More use of electronics and software instead of mechanical function.  Assumes ... Its replacement is difficult, that it is difficult to change old system to new system. 

thumb_up_alt 0 like thumb_down_alt 0 dislike
1.8k views 1 answer
Description :

What are the disadvantages of Open loop control system?

Answer :

Open loop control system are less reliable. In open loop control system Optimization is not possible. Open loop control system are less accurate.

thumb_up_alt 0 like thumb_down_alt 0 dislike
67 views 1 answer
Description :

What are the components of system bus? A) CPU Bus, Address Bus, Data Bus B) Memory, Control Unit, ALU C) Data Bus, Address Bus, Control Bus D) Register, PC, IR

Answer :

What are the components of system bus? A) CPU Bus, Address Bus, Data Bus B) Memory, Control Unit, ALU C) Data Bus, Address Bus, Control Bus D) Register, PC, IR

thumb_up_alt 0 like thumb_down_alt 0 dislike
2.1k views 1 answer
Description :

The clock frequency of an 8085 microprocessor based system is 3 MHz. What should be the minimum pulse width of the INTR signal so that it is recognized successfully? A) 5.6 µs B) 5.7 µs C) 5.8 µs D) 5.9 µs

Answer :

The clock frequency of an 8085 microprocessor based system is 3 MHz. What should be the minimum pulse width of the INTR signal so that it is recognized successfully? A) 5.6 µs B) 5.7 µs C) 5.8 µs D) 5.9 µs

thumb_up_alt 0 like thumb_down_alt 0 dislike
560 views 1 answer
Description :

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Answer :

What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

thumb_up_alt 0 like thumb_down_alt 0 dislike
179 views 1 answer
Description :

What is the time response of a system whose poles lie on the right hand side of s-plane? A) Exponentially increasing B) Exponentially decreasing C) Sinusoidal oscillations D) Step response 

Answer :

What is the time response of a system whose poles lie on the right hand side of s-plane? A) Exponentially increasing B) Exponentially decreasing C) Sinusoidal oscillations D) Step response 

thumb_up_alt 0 like thumb_down_alt 0 dislike
76 views 1 answer
Description :

What is the traction system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
100 views 0 answers
Description :

What is stable and unstable system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
64 views 0 answers
Description :

What is the impulse response of the system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
65 views 0 answers
Description :

What is a time variant system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
64 views 0 answers
Description :

What is the meaning of LTI system?

Answer :

The system which satisfies both linearity and time invarient is called linear time invarient (LTI) systrm

thumb_up_alt 0 like thumb_down_alt 0 dislike
114 views 1 answer
Description :

What do you mean by signal and system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
55 views 0 answers
Description :

What is a fuzzy inference system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
71 views 0 answers
Description :

What is meant by fuzzy system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
59 views 0 answers
Description :

What are some examples of a closed loop system?

Answer :

C.L s/m. EX. Air conditioner (AC), rocket launcher, radar system, voltage stabilizer etc.

thumb_up_alt 0 like thumb_down_alt 0 dislike
91 views 1 answer
Description :

What is a servomechanism system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
46 views 0 answers
Description :

What is an example of an open loop system?

Answer :

Open loop system. Ex. Electric heater, washing machine, fan, electric switch, etc

thumb_up_alt 0 like thumb_down_alt 0 dislike
91 views 1 answer
Description :

What is the automatic control system?

thumb_up_alt 0 like thumb_down_alt 0 dislike
52 views 0 answers
editAsk a Question
...