search
person
Which configuration has the lowest current gain ?

1 Answer

Common base configuration has the lowest current gain.

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : What is the current gain?

Answer : Current gain β = Ic/Ib

Description :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be A) 0.98 B) 0.41 C) 59 D) 55  

Answer :  If the base current of a BJT is 250 µA and emitter current is 15 mA, then the common base current gain will be 0.98 

Description : Which of the following has the lowest electrical conductivity? A) Mercury B) Silver C) Copper D) Gold

Answer : Which of the following has the lowest electrical conductivity? A) Mercury B) Silver C) Copper D) Gold

Description : Which of the following waveforms has the lowest form factor? A) Sine wave B) Square wave C) Sawtooth wave D) Triangle wave

Answer : Which of the following waveforms has the lowest form factor? A) Sine wave B) Square wave C) Sawtooth wave D) Triangle wave

Description : A differential amplifier has a differential gain of 28000 and CMRR is 60 dB. What will be the value of common mode gain? A) Ac = 0.125 B) Ac = 0.33 C) Ac = 3 D) Ac = 28 

Answer : A differential amplifier has a differential gain of 28000 and CMRR is 60 dB. What will be the value of common mode gain? A) Ac = 0.125 B) Ac = 0.33 C) Ac = 3 D) Ac = 28 

Description : The lowest eigenvalue of the 2x2 matrix 

Answer : Linear Algebra Problem The lowest eigenvalue of the 2x2 matrix https://youtu.be/QatcRTzF7EA

Description : What is the lowest acceptable insulation resistance for a cable?

Description : Draw O/P characteristics of CB configuration and explain its working.

Answer : In common base configuration, emitter is the input terminal, collector is the output terminal and base terminal is connected as a common terminal for both input and output. The base-emitter ... In this region, a small collector current flows called leakage current when emitter current is zero.

Description : Draw full bridge & half bridge configuration with common cathode.

Answer : Half Bridge Configuration: Full Bridge Configuration: 

Description : Sketch output characteristics of CE configuration. Show all the regions.

Answer : Sketch output characteristics of CE configuration. Show all the regions.

Description : Compare between CB , CE & CC transistor configuration.

Answer : Parameter CB CE CC I/P impedance Low Or 50Ω Medium Or 600Ωto 4kΩ High Or 1 MΩ Current Gain Less than or equal to 1 High Highest Voltage Gain Medium Medium Less ... k Ω to 50 k Ω Low Or 50 Ω Phase shift between input and output 0° 360° 0° 

Description : Why common emitter configuration is commonly used?

Answer : Common emitter configuration is commonly used for amplifications because 1. The common emitter configuration (CE) provides maximum voltage and current gain and hence provides maximum power gain. The ... automatic impedance matching maximum power transfer will take place from one stage to other.

Description : In relation to embedded Linux how TCP/IP networking is done? Explain network configuration.

Description : Explain MOSFET gate drive circuit and totem pole configuration.

Answer : MOSFET gate drive circuit: The turning on and turning off of MOSFET can be controlled from gate to source voltage signal. If the gate to source voltage of MOSFET exceeds threshold ... this configuration, the two switches (transistors) are used in totem pole arrangement with a comparator.

Description : The effect of a finite gain of an operational amplifier used in an integrator is that (A) it would not integrate (B) the slope of the output will vary with time (C) the final value of the output voltage will reduce (D) there will be instability in the circuit

Answer : The effect of a finite gain of an operational amplifier used in an integrator is that there will be instability in the circuit

Answer : The voltage gain of triode depends on plate voltage.

Description : A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by

Answer : A differential amplifier has a differential gain of 20,000, CMRR : 80 dB. The common mode gain is given by 2

Description : A transfer function has a second order denominator and constant gain in the numerator

Answer : A transfer function has a second order denominator and constant gain in the numerator the system has two zeros at infinity

Description : An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is  (1) 141 (2) 92.3 (3) 9.23 (4) 1.41

Answer : An amplifier has a voltage gain of 120. To reduce distortion, 10% negative feedback is employed. The gain of the amplifier with feedback is 9.23

Description : Define gain and bandwidth of an amplifier.

Answer : Bandwidth  The range of frequency over which the voltage gain is equal to or greater than 70.7% of its maximum value Gain: The ratio of output parameter (voltage/ current /power) to the input parameter (voltage/ current /power) of an amplifier is known as gain. It is denoted by a letter A

Description : The unity gain bandwidth of an inverting amplifier is 10 MHz What would be the bandwidth if the gain is increased to 10 V/V? A) 100 MHz B) 1 MHz C) 10 MHz D) 1 kHz 

Answer : The unity gain bandwidth of an inverting amplifier is 10 MHz What would be the bandwidth if the gain is increased to 10 V/V? A) 100 MHz B) 1 MHz C) 10 MHz D) 1 kHz 

Description : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Answer : What will happen to the gain margin if the gain of the open loop system is doubled? A) Doubled B) Becomes half C) Is not affected D) Becomes one-fourth 

Description : The voltage gain of a common -source JFET amplifier depends up on its  (1) Input impedance (2) Amplification factor (3) Dynamic drain resistance (4) Drain load resistance

Answer : 2

Description : If the gain of the open loop system is doubled, the gain margin  (1) Is not affected (2) Gets doubled (3) Becomes half (4) Becomes one -forth

Answer : If the gain of the open loop system is doubled, the gain margin Becomes half

Description : The gain of an ideal amplifier must be

Answer : The gain of an ideal amplifier must be infinity

Description : What is Mason's gain formula?

Answer : Mason's Gain Formula

Description : What is the gain of an op amp?

Description : Define: i) Input Offset Voltage ii) Input offset Current iii) Input Bias Current iv) Output offset voltage

Answer : Definition of parameters of OPAMP is follows:  i) Input Offset Voltage: Input offset voltage is defined as the voltage that must be applied between the two input terminals of an OPAMP to null or ... to ground) and output voltage is obtained non zero such voltage is output offset voltage of opamp.

Description : The leakage current of PN junction is caused by?

Answer : The leakage current of PN junction is caused by heat energy.

Answer : In Reverse bias of diode when the cathode is connected to positive and anode is connected to negative very small current flows this very small current is known as leakage current of diode.

Answer : In  BJT  there  is  movement  of   electrons  and  holes   accros  the  junctions  which  is  basicaly  current  flow.

Description : A linear network has a current input 4cos(ω t + 20º)A and a voltage output 10 cos(ωt +110º) V. Determine the associated impedance.

Answer : Solution

Description : A zener voltage regulator has load requirements of 12 V and 2 A. The zener diode minimum current requirement is 0.2 A. The minimum voltage at input is 24 V. What is the required value of series resistance with source? A) 5.45 Ω B) 6 Ω C) 7.2 Ω D) 6.38 Ω  

Answer : A zener voltage regulator has load requirements of 12 V and 2 A. The zener diode minimum current requirement is 0.2 A. The minimum voltage at input is 24 V. What is the required value of series resistance with source? A) 5.45 Ω B) 6 Ω C) 7.2 Ω D) 6.38 Ω  

Description : A ferrite core has less eddy current loss than an iron core because?

Answer : A ferrite core has less eddy current loss than an iron core because ferrites have high hysteresis.

Answer : The gravity controlled instrument has crowded scale because current is proportional to sine of deflection angle.

Answer : In a synchronous motor, the armature current has large values for high and low excitation.

Description : Identify type of BJT configuration having following features : (i) BJT configuration having the least current gain. (ii) KIT configuration called as voltage follower. (iii) BJT ... configuration suitable for voltage amplification. (vi) BJT configuration having the least output impedance.  

Answer : (i) BJT configuration having the least current gain : Common Base Configuration  (ii) KIT configuration called as voltage follower: Common Collector Configuration  (iii) BJT ... Emitter Configuration  (vi) BJT configuration having the least output impedance: Common Collector Configuration

Description : Compare BJT common base configuration with common collector configuration on the basis of (i) Current gain (ii) Voltage gain (iii) Input impedance (iv) Output impedance

Answer : Parameter Common Base Common Collector Current gain Low (About 1) High (1+β) Voltage gain High 1  Input impedance  Low High Output impedance High Low

Description : For highest power gain, what configuration is used: (1) CC (2) CE (3) CB (4) CS

Answer : For highest power gain, what configuration is used: (1) CC (2) CE (3) CB (4) CS

Description : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Answer : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Description : Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

Answer : Which of the following theorems enables a number of voltage (or current) source to be combined directly into a single voltage (or current) source. (1) compensation theorem (2) reciprocity theorem (3) superposition theorem (4) Millman's theorem

Description : Which of the following can reduce the Eddy current losses? A) By making the core of a stack of plates electrically insulated from each other B) By making the core of solid block C) By increasing the applied voltage  D) None of these

Answer : Which of the following can reduce the Eddy current losses? A) By making the core of a stack of plates electrically insulated from each other B) By making the core of solid block C) By increasing the applied voltage  D) None of these

Description : An instrument which detects electric current is known as?

Answer : An instrument which detects electric current is known as galvanometer.

Description : In which fault the maximum short circuit current occurs?

Answer : In three phase bolted fault the maximum short circuit occurs.

Description : Electrical shock happens for voltage/current?

Answer : The severity ofelectric shockdepends on thecurrentflowing through the body, which is a function of the electromotive force (E) involts, and the contact resistance (R) in ohms.

Description : Analyze the effect of supply voltage on performance of LED as regards current, Lumen output, efficacy and life. 

Answer : 1) Effect on Current:- In LED current depends upon supply voltage, if voltage get changes then current also change but this change in current will be control by resistors which are connected in series.  2) ...   4) Effect on Life:- If supply voltage is not stable then life of LED get reduced. 

Description : With the help of N-channel JFET describe the effect of input voltage VGS on output current ID.

Answer : Working of N channel FET: * When a voltage is applied between the drain and source with a DC supply (VDD), the electrons flows from source to drain through narrow channel ... where the channel gets completely blocked and the drain current becomes zero is called pinch- off voltage. 

Description : Even at no-load, a transformer draws current from the mains. Why?

Description : Current division rule example

Answer : Current division rule example

Description : Current division

Answer : Current division

← Prev Question Next Question →
editAsk a Question
...