3 Answers

No, we need neutral wire to get voltage difference.
Like 0 like Dislike 0 dislike
The bulb will light due to phase voltage (415v)
Like 0 like Dislike 0 dislike
Due to no potential difference between the ends of the circiut there is no existance of current 
Like 0 like Dislike 0 dislike
There is a 415 line voltage.

Related questions

Description : In a three-phase supply floating neutral is undesirable because it way give rise to?

Answer : In a three-phase supply floating neutral is undesirable because it way give rise to unequal line voltages across the load.

Description : What happens when a neutral wire touches a phase wire ?

Answer : Maximum current flow due to Short circuit, limited value of fuse will burn else apparatus and conductor will be damaged.

Description : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Answer : Nodal Analysis with Voltage Sources dependent voltage source and two supernode

Answer : Ungrounded neutral transmission system is not recommended because of system insulation being overstressed due to over voltages, insulation overstress may lead to failure and subsequent phase to phase faults, being inadequately protected against ground fault.

Description : The magnetic neutral plane shifts in a dc machine (A) in the direction of motion of motor (B) in the direction of motion of generator (C) due to increase in the field flux (D) cause reduction of flash over between commutator segments

Answer : The magnetic neutral plane shifts in a dc machine in the direction of motion of generator

Answer : In a D.C. generator the magnetic neutral axis coincides with the geometrical neutral axis, when there is no load on|he generator.

Description : Explain the meaning of following terms: i) MCB ii) Socket outlet iii) Neutral iv) Fuse-link

Answer : i) MCB:  Miniature circuit breaker operates automatically at the time of fault or over load. And it is used for the protection of electrical installation. They are available from 0.5 A to 100 Amps. ... melts automatically at the time of fault or over load. Fuse must be replaced after the fault.

Description : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ?

Answer : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ? Δ-Δ connection

Description : Which color wire is neutral?

Answer : Black but I think it depends with the place.

Description : Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume (A) 90 W (B) 80 W (C) 60 W (D) 180 W

Answer : Two light bulbs are connected in series across a 120 V battery. Bulb 1 uses 40 W of power and Bulb 2 uses 20 W of power. If bulb 1 alone is connected to the 120 V source, then it will consume 90 W

Description : Write two applications of D.C. series motor. 

Answer : The applications of D.C. series motor: 1. Cranes 2. Hoists 3. Trolley and cars 4. Conveyors 5. For traction work i.e. electric locomotives 6. Elevator 7. Air compressor

Answer : The two pressure coils of a single phase power factor meter have the same dimensions and the same number of turns.

Description : When your motor-bike is out of order all of sudden then what will you do in this situation? Options: A) You will immediately get the bike repair because you feel inferiority to go ... immediately otherwise it will be deteriorated D) You will become neutral as you believe to face every condition

Answer : C) You will get it repaired immediately otherwise it will be deteriorated

Answer : In two part tariff, variation in load factor will affect operating or running charges.

Description : If resistance is 8 Ohm and current is 16 ampere then what will be the voltage and power?

Answer : 128 volts ,2048 watts

Description : If 1-phase voltage is 220V, why is 3-phase 440V and not 660V ?

Answer : Phase voltage =220v /( phase to neutral) Line voltage = 380 v ( phase to phase) Phase angle difference 120° So when two phases reach vmax +ve I.e. (+220v) + (+220v) = 440v that time due ... these event happen very fast. Hence we have 440 v only in three phase motor. √3.phase voltage= 380 v.

Description : Name two good conductors, two good insulators, and two semiconductors.

Answer : In general all metals are good conductors, with silver the best and copper second.

Description : State any two advantages of MCB over Fuse. State the standard specifications of MCB available in the market.  

Answer : Following advantages of MCB over Fuse: 1. No need of replacement of fuse wire. 2. Manually restore of supply is simple. 3. Fault understanding by visual inspection 4. More safe than fuse The standard specifications of ... 6A, 10A,16A,20A, 25A, 30A, 32A, 40A, 50A, 60A and 63A 6. 250V and 450 v

Description : List two types of oscillator, which generates frequency in RF range.

Answer : Types of Oscillators generating frequencies in RF range: i) Hartley Oscillator ii) Colpitt’s Oscillator iii) Clapp Oscillator

Description : Application one lamp controlled from two places

Answer : Application one lamp controlled from two places: 1. For Stair case wiring 2. Hospital Wiring ( For operating the lamp in room and nursing station) 3. Bedroom Lighting. 

Description : State two applications of : (i) PVC paper (ii) Porcelain with type of class based on withstand temperature is insulating material. 

Answer :  (i) Application of PVC paper : 1. It is used in slot lining or motor winding insulation purpose 2. For Insulation of Transformer winding (ii) Application of Porcelain : 1. Mainly used for manufacturing ... on withstand temperature : * H' & C' Class of insulation i e. 180° and above 180°C 

Description : List at least two examples that show how static electricity can be generated.

Answer : Examples of how static electricity can be generated include combing your hair, walking across a carpeted room, or sliding two pieces of plastic across each other.

Description : Merits of two wattmeter method

Answer : Advantages of Two Wattmeter Method for 3-Phase Power Measurement: 1) It is used for balanced as well as unbalanced load. 2) For the star type load, it is not necessary to ... reactive volt-amperes for balanced loads also. 7) The circuit connections are independent of load connection.

Description : Which one of the following is true? (A) The resolvent of two Horn clauses is not a Horn clause. (B) The resolvent of two Horn clauses is a Horn Clause. (C) If we resolve a negated goal G against a ... negated goal G against a fact or rule A to get clause C then C has positive literal or null goal. 

Answer : (B) The resolvent of two Horn clauses is a Horn Clause.

Description : Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then .  A) The bulbs together consume 100 W B) The bulbs together consume 50 W C) The 60 W bulb glows brighter D) The 40 W bulb glows brighter

Answer : Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then . The bulbs together consume 50 W 

Description : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Answer : What is the RMS voltage in a series RL circuit, if the voltage across R and L is 256 V and 192 V respectively? A) 320 V B) 448 V C) 64 V D) None of these

Answer : In order that current should flow without causing excessive heating or voltage drop, the relay contacts should have low contact resistance, be clean and smooth, be of sufficient size and proper shape.

Description : Two port networks are connected in cascade. The parameters of the network are obtained by multiplying in individual

Answer : Two port networks are connected in cascade. The parameters of the network are obtained by multiplying in individual ABCD parameter matrix

Answer : In a two value capacitor motor, the capacitor used for running purposes is paper spaced oil filled type.

Description : Three 60 W bulbs are in parallel across the 230 V power line. If one bulb burns out

Answer : Three 60 W bulbs are in parallel across the 230 V power line. If one bulb burns out the other two bulbs will remain glowing

Description : Illustrate with neat wiring diagram a single lamp control by two point method.

Answer : Single lamp control by two point method:  This system is commonly used for stair case wiring. It consists of two way switches (the switch operates always in one of the two possible positions) the ... the person will change the position of switch S2, so that the lamp will be switched OFF'.

Description : State two types of Electronic dimmer.

Answer : Two types of electronic dimmers are: 1) S.C.R. operated dimmer 2) Triac operated dimmer 

Description : Mesh Analysis with two supermesh

Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

Description : Nodal analysis problem two current source

Answer : Nodal analysis problem two current source

Description : Draw construction of SCR using two transistor model. Explain its operation.

Answer : Two Transistor Model of SCR or Thyristor

Description : Explain two-quadrant chopper.........

Answer : Two quadrant chopper:  There are two semiconductor controllable switches in the two-quadrant chopper. Two quadrant type A chopper: The figure shows the type A chopper. Both the switch never turn on at ... 2 are turned on then Vo=Vs. When chopper 1 and chopper 2 are off then Vo=-Vs.

Description : The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be :  (A) 34.64 kVA (B) 75 kVA (C) 20 kVA (D) None of the above

Answer : The kVA rating of Three-phase transformer with Voltage = 200V and Current = 100A will be : 34.64 kVA

Description : Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

Answer : Which of the following connection of transformers will give highest value of secondary voltage ? (A) Delta primary delta secondary (B) Delta primary star secondary (C) Star primary star secondary (D) Star primary delta secondary

Description : Is the filament resistance lower or higher in a 500 watt light bulb than in a 100 watt light? Assume that both bulbs have been designed to operate at 110 volts. 

Answer : ANSWER: LOWER

Description : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is :

Answer : A 3-phase voltage source inverter operates in 180° conduction mode with a star connected resistive load. If input dc voltage is 100 V, then the peak to peak output line voltage is : 200 V

Description : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

Answer : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across Rl.

Answer : There are three 100 bulbs in parallel across 220 V.50 Hz line. If one bulb burns out: Remaining two bulbs will produce light.

Description : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open?

Answer : Three 60 W bulbs are in parallel across the 60 V power line. If one bulb burns open the other two bulbs will light.

Description : For a parallel connection of light bulbs, which of the following statements is correct? w) The resistance of each light bulb must be the same. x) If one goes out they all go out. y) Each of the light bulbs operates independently.

Answer : ANSWER: Y -- EACH OF THE LIGHT BULBS OPERATES INDEPENDENTLY.

Description : A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will

Answer : A network contains linear resistors and ideal voltage sources. If values of all the resistors are doubled then the voltage across each resistor will not change

Description : Which of the following are correct ways of arguing ? (i) There can be no second husband without a second wife. (ii) Anil is a friend of Bob, Bob is a friend of Raj, hence Anil is a friend of Raj. (iii) A is equal to B, B ... , (iii) and (iv) (C) (ii), (iii) and (iv) (D) (i), (ii), (iii) and (iv)

Answer : (A) (iii) and (iv)

Description : if the displacement of a particle is zero, then what can we say about its distance covered ? (a) it must be zero. (b) it cannot be zero. © it is negative (d) it may or may not be zero.

Description :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when A) ZL = R B) ZL = jXS C) ZL = R-jXS D) ZL = R+jXS 

Answer :  An independent voltage source in series with an impedance ZS=R+jXS delivers a maximum average power to a load impedance ZL when ZL = R-jXS

Description : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Answer : Consider a circuit with four resistors in series connected to a voltage source. What happens to the voltage across each resistor, if the value of each of the resistors is doubled? A) It will double B) It will remain the same C) It will be halved D) It will become zero

Description : The voltage gains of the amplifier with and without feedback are 20 and 100 respectively. The percentage of negative feedback would be

Answer : The voltage gains of the amplifier with and without feedback are 20 and 100 respectively. The percentage of negative feedback would be 4%

← Prev Question Next Question →
Ask a Question
Choose topic