search
person
What is the EMF equation of the transformer?

1 Answer

E1 =2(3.142)fN1 (flux)1

E2 =2(3.142)fN2(flux)2

thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : A parallel RLC circuit has the node equation Determine v(t) using the phasor method.

Answer : A parallel RLC circuit has the node equation Determine v(t) using the phasor method.

Description : The loop equation for a series RLC circuit gives

Answer : The loop equation for a series RLC circuit gives

Description : State RADAR range equation and write factor influencing maximum range.

Answer : Free Space RADAR range Equation: 1.RADAR range equation relates the range of a RADAR to the chara. Of Tx, Rx, Antenna, target & environment. 2.Free space means RADAR and target are isolated in ... is no obstacle between RADAR antenna & the target. 4.There will be No absorption of EM waves.

Description : The equation of 50 Hz current sine wave having r.m.s. value of 60 A is?

Answer : (60*√2)Sin(2π*50*t)

Description : What is back emf? 

Answer : Back EMF: When a current carrying conductor is placed in a magnetic field it experiences a force; when it moves due to the force it (conductor) cuts the magnetic field due to which an emf is ... (hence the applied armature voltage) is opposed by the induced emf which is therefore called as Back emf.

Description : What is Phase sequence? Draw waveforms of 3 phase emf.

Answer : Phase sequence: It is the order in which the three phases reach their peak or maximum values. It is shown in below fig. the phase sequence is A-B-C (or R-Y-B). In the following waveforms, it is ... 120º, B- phase voltage attains its positive maximum value. So the phase sequence is R-Y-B. 

Description :

What is back EMF of synchronous motor?

Description :

What is back EMF in inductor?

Description : What is the back EMF in Transformers?

Description : What is the back EMF of a dc motor?

Description : What is the back EMF of the motor?

Description : What is the back EMF?

Answer : When the armature of a d.c. motor rotates under the influence of the driving torque, the armature conductors move through the magnetic field and hence e.m.f. is induced in them as in a generator. The ... that energy conversion in a d.c. motor is only possible due to the production of back emf.

Description : Explain dynamic and static induced emf with neat diagram.

Answer : Dynamically Induced EMF:-  In this case, either coil moves or magnet moves, so that there is relative motion between coil & magnetic field. Thus magnetic field is cut by coil & emf is induced in it. The emf ... The expression for induced EMF is e= -L(di/dt) or = -N(dϕ/dt).

Description : Self induced emf and Mutually induced emf

Answer : (i) Self-induced e.m.f.: The e.m.f. induced in a coil due to the change of its own flux linked with it, is called self-induced e.m.f.  (ii) Mutually induced e.m.f.: The e.m.f. induced in a coil due to the changing current in the neighbouring coil, is called mutually induced e.m.f. 

Description : Compare statically induced emf with dynamically induced emf on any four points.

Answer : Statically induced emf Dynamically induced emf Emf is induced without any relative motion between conductor and magnetic field. Emf is induced due to relative motion between conductor ... induced in transformer windings e.g emf induced in Generator, Alternator armature windings

Description : Explain the term self induced EMF with a neat diagram.

Description : Define: 1) statically induced EMF 2) dynamically induced EMF Write the names of equipments in which these two types of EMF get induced

Answer : Concept of statically induced emf: The emf induced in coil or conductors without any relative motion between it and magnetic field is called statically induced emf. When conductor is stationary and flux ... it. This emf is dynamically induced emf. e.g. Emf induced in generators, alternator.

Description : List the two types of induced EMF.

Answer : There are two types of EMF one is statically induced EMF and second is dynamically induced EMF.

Description : The induced emf in the armature of a lap -wound four -pole dc machine having 100 armature conductors rotating at 600 rpm and with 1 Wb flux per pole is  (1) 1000V (2) 100V (3) 600V (4) 10,000V

Answer : The induced emf in the armature of a lap -wound four -pole dc machine having 100 armature conductors rotating at 600 rpm and with 1 Wb flux per pole is 1000V

Description : The fractional-pitch used for eliminating 7th harmonic from the emf wave of an alternator is (A) 2/3 (B) 5/6 (C) 7/8 (D) 6/7

Answer : The fractional-pitch used for eliminating 7th harmonic from the emf wave of an alternator is 6/7

Description :

The back emf of synchronous motor depends on?

Answer : The back emf of synchronous motor depends on load angle.

Description : Do AC induction motors have back EMF?

Description :

Answer : The value of flux involved in the e.m.f. equation of a transformer is maximum value.

Description : Draw the Delta connected three phase system showing all the voltages and currents. Write the power equation.

Description : Write the Emf equation of transformer. State the meaning of each term in it. 

Answer : EMF equation of Transformer:- E1 = 4.44 f ØmN1 OR E1 = 4.44 f BmAN1 E2 = 4.44 f ØmN2 OR E2 = 4.44 f Bm AN2 Let, E1 = Primary emf E2 = Secondary emf N1= Number of turns in the primary N2 ... flux in core (wb) Bm= Flux density (wb/m2 /Tesla) A= Area of cross section of core m2 F = Frequency 

Description : (a) Define permeability. (b) Define MMF. (c) Define form factor of an alternating quantity. (d) Define frequency and time period of an alternating quality. (e) Define transformation ratio of transformer. (f) State the EMF equation of a 1 transformer and state the meaning of each term used. (g) Give two applications of single phase motors. 

Answer : Permeability : It is the ability of a magnetic/Non magnetic material to allow setting up of flux in it.  MMF : The magneto motive force (MMF) is the force required to setup flux in a magnetic / ... applications of single phase motors : Water pumps, ceiling fan, lathe machine

Description :

Answer : The armature may burn if the back e.m.f. of a D.C. motor vanishes suddenly.

Description : What is temperature rise in a transformer?

Answer : Temperature rise in a transformer is the temperature of the windings and insulation above the existing ambient or surrounding temperature.

Description : What is a transformer and how does it work?

Answer : A transformer is an electrical apparatus designed to convert alternating current from one voltage to another. It can be designed to step up or step down voltages and works on the magnetic ... or voltage ratio) between the primary and secondary depends on the turns ratio of the two coils.

Description : What is the use of transformer?

Answer : The use of transformer  is to do lower or raise  the voltage or currents in an electrical  circuit.  That's quite so simple. 

Description : What is the back E.M.F in Transformer ?

Answer : Back emf in transformer is when apply voltage in primary side of transformer. This voltage produce flux according to Faraday law electro magnetic induction. This flux called mutual flux and this ... secondary flux oppos the applied voltage according to lenz law. its called back emf of transformer

Description : What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Answer : What will happen if the primary of a transformer is connected to D.C. supply?  (A) Transformer will operate with low efficiency (B) Transformer will operate with high efficiency (C) No effect (D) Transformer may start to smoke and burn 

Description : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be excessive  (B) Current will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Answer : What would happen if a power transformer designed for operation on 50 Hz (frequency) were connected to a 500 Hz (frequency) source of the same voltage:  (A) Eddy Current and Hysteresis losses will be ... will be too much high  (C) Transformer may start to smoke and burn  (D) No effect

Description : What is a capacitor voltage transformer? A) It is a transformer used in power systems to step up low voltage signals and provide extra high voltage B) It is a transformer used in power systems to step up high voltage signals and provide extra high voltage C) It is a transformer used in power systems to step down extra high voltage signals and provide low voltage D) None of these

Answer : What is a capacitor voltage transformer? A) It is a transformer used in power systems to step up low voltage signals and provide extra high voltage B) It is a transformer used in power systems ... power systems to step down extra high voltage signals and provide low voltage D) None of these

Description : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ?

Answer : To protect the power transformer (Y-Y with neutral grounded) against fault, what type of connection do the CTs have ? Δ-Δ connection

Description :

what do not change in transformer?

Answer : Frequency and power are constant in transformers. Suppose we apply 50 Hz input frequency then the output frequency will also be 50 Hz whether the transformer is step up or step down. Similar ... is decreased on secondary side and hence power on primary side and secondary side remains constant.

Description : What is an auto transformer starter?

Description :

What is impulse voltage of transformer?

Description : What are the design constraints of transformer design?

Answer : Design constraints of transformer design: Core loss, flux density, copper loss and total power loss vs flux density these are the basic constraints in transformer design. Core loss: Flux density: Copper loss: Total power loss vs flux density:

Description : What is the use of Buchholz relay in transformer?

Answer : This is a transformer that is used to step up and down current. 

Description :

Answer : Transformer noise is generated due to vibration of core and winding this is because of magnetostriction and magnetomotive force.

Description :

Answer : In short circuit test of transformer the low voltage side is short circuited . On high voltage side the voltmeter is connected in parallel and ammeter in series and also a wattmeter is ... circuit test is done for determining impedance and losses. In this test iron losses is neglected.

Description : what is mean by rotating transformer ?

Answer : Induction motor is a rotating transformer

Description : The counter e.m.f. of a d.c. motor?

Answer : The counter e.m.f. of a d.c. motor helps in energy conversion.

Description :

Answer : E.m.f. of a Weston cell is accurately measured by electrostatic voltmeter.

Description :

Answer : It is required to measure the true open circuit e.m.f. of a battery. The best device is D.C. potentiometer.

Description :

Answer : If B is the flux density, I the length of conductor and v the velocity of conductor, then induced e.m.f. is given by Blv.

← Prev Question Next Question →
editAsk a Question
...