search
person
write short notes on Low-pass filter.

2 Answers

that passessignalswith afrequencylower than a certaincutoff frequencyandattenuatessignals with frequencies higher than the cutoff frequency. The exactfrequency responseof the filter depends on thefilter design. The filter is sometimes called ahigh-cut filter, ortreble-cut filterin audio applications. A low-pass filter is the complement of ahigh-pass filter.

thumb_up_alt 1 like thumb_down_alt 0 dislike
Low-pass filters exist in many different forms, including electronic circuits such as a hiss filter used in audio, anti-aliasing filters for conditioning signals
low-pass filter

(1) filter exhibiting frequency selective characteristic that allows low-frequency components of an input signal to pass from filter input to output unattenuated all high-frequency components are attenuated. 

(2) a tuned circuit designed to pass all frequencies below a designated cut-off frequency.

(3) a filter that passes signal components whose frequencies are small and blocks (or greatly attenuates) signal components whose frequencies are large. For the ideal case, if H(ω) is the frequency response of the filter, then H(ω) = 0 for |ω| > B, and H(ω) = 1 for |ω| < B. The parameter B is the bandwidth of the filter. A filter whose impulse response is a low-pass signal.
thumb_up_alt 0 like thumb_down_alt 0 dislike

Related questions

Description : What do you mean by active filter? State its advantages over passive filter . Define pass band & stop band with respect to filter.

Answer : Active Filter: Active Filter is formed by using active element along with the passive components.  Advantages of Active filter over Passive filter: High value of pass band gain can be obtained. It is ... pass band.  Stop Band Filter: The frequency range which is attenuated is known as stop band.

Description : Write short notes on diode.

Answer : Diode is made from semiconductor material like silicon or germanium. Diode may use as rectifier which convert AC to DC. It is a electronic component. It is two terminal device, one is anode and second is ... in one direction. Diode is made from P-type and N-type material. Diode have a PN junction.

Description : Write short notes on Arduino.

Answer : Arduino: Arduino is a open source hardware and software. Arduino is a microcontroller. Since Arduino is open source it have many manufacturer. Arduino project was started in about year ... many sensors to the Arduino. Arduino board have microprocessor, crystal oscillator, 5V voltage regulator.

Description : Write short notes on:  1) Phosphor characteristics  2) Liquid crystal display

Description : write short notes on single phase system.

Answer : A "phase" in an electrical system is often referred to as the waveform (may be voltage or the current) of the power supply. The waveform in an AC system is typically ... domestic household or commercial supplies and street lighting. Industrial supplies requires three phase electrical supply .

Description : write short notes on BH curve.

Answer : The B-H curve is the relation between Flux density B in Wb/m2 (on Y Axis) and H in AT/m (on X axis) It is also known as magnetization characteristics. This curve particularly useful ... occurs. At point A' material gets magnetically saturated and the curve becomes flat (parallel to X axis) 

Description : write short notes on Linear motor.

Answer : Normal electrical motor produces rotatory motion same the linear motor produces linear motion. Linear motors have low efficiency. Linear motor can directly produce straight line motion linear motor do not required gears or crank shaft to produce linear motion.

Description : What is the harmonic filter?

Answer : It is being used to supress the input voltage distortion at input side of any electrical equipment. This distortion is created by other electrical loads like motor, drives etc nearby connected with ... for a range of harmonics or specific harmonics like 3rd harmonics  5th harmonics, 7th harmonics. 

Description : Which capacitors are suitable for DC filter circuits?

Answer : Electrolytic capacitors are suitable for DC filter circuits.

Answer : A synchronous machine with low value of short-circuit ratio has lower stability limit.

Description : A 1000Ohm, 1 Watt resistor can safely pass a current of

Answer : A 1000 Ohm, 1 Watt resistor can safely pass a current of 30 mA

Description : What kinds of materials can not electricity pass through?

Description : Explain the single pass transformer design procedure step by step by giving its flowchart.

Answer : single pass transformer design procedure step by step by giving its flowchart:

Description : need of rectifier and filter. 

Answer : Need of rectifier: Every electronics circuit needs a D.C. power source for its operation. The rectifier circuit is used to convert A.C. supply to unidirectional pulses .  Need of filter: A filter ... only the D.C. components to reach the load. So filter is used to provide ripple free output.

Description : What is the function of an electrical filter ?

Answer : Filter separates different components that are mixed together. Electrical filter can separate different frequency components. Electrical filters are the electrical circuits which are use to remove unwanted frequency components from the signal.

Description : State any four advantages of LC filter.

Answer : 1. The choke input (LC) filter has a high output D.C voltage. 2. It has no loading effect on the rectifier and power transformer.  3. The diode does not have to carry surge currents.  ... effect on the rectifier and power transformer.  7. It has better voltage regulation than that of π filter.

Description : Compare RC and LC filter.

Answer : RC filters  LC filters The RC filter is only useful for small load currents. The LC filters are useful for heavy load currents. More power dissipated in RC filter. Less power ... RC is fine for filtering low power signals. LC is fine for filtering high power signals.

Description : What is the convolution filter?

Description : Explain design constraint of filter inductor design.

Description : In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the (A) applied load (B) internal compensation (C) impedance of the source (D) power dissipation in the chip

Answer : In a 741 Op-Amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to the internal compensation

Answer : MOSFET have high current losses due to High on state resistance. Hence MOSFET is used for low power applications.

Description : Name two methods for measurement of low, medium and high resistance. Give one advantage and one limitation of V- I method.

Answer : Methods for measurement of low resistance:  1. Ammeter voltmeter method  2. Kelvin's bridge method  3. Ohm meter method  4. Potentiometer method  5. Digital/analog multi-meter ... must be infinity for perfectly accurate measurement which is not possible.  2. Connection errors.

Description : Name the method used to measure following resistances:- (i) Low resistance (ii) Medium resistance (iii) Insulation resistance (iv) Earth resistance.

Answer : Following are the methods used to measure resistances:-  (i) Low resistance: 1.Voltmeter-Ammeter Method 2. Kelvin's Double bridge Method  (ii) Medium resistance: 1.Voltmeter-Ammeter Method 2. ... of Charge Method  (iv) Earth resistance : 1. Fall of Potential Method 2. Earth tester

Description : State the range for low and medium resistance.

Answer : Low resistances: less than 1 ohm.  Medium resistances: 1 ohm to 0.1 Mega ohm. 

Description : Step-down transformer converts high voltage and low current into:  (A) How voltage and high current (B) High voltage and low current (C) Low voltage and high current (D) None of the above

Answer : Step-down transformer converts high voltage and low current into: Low voltage and high current

Description : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Answer : Which of the following is the least expensive protection for over current in low voltage system?  (A) Rewireable fuse (B) Isolator (C) Oil Circuit breaker (D) Air break circuit breaker

Description : Accurate measurement of very low resistances is possible with (A) Megger (B) Wheatstone Bridge (C) Kelvin’s Double Bridge (D) Wagner’s Earthing Device

Answer : Accurate measurement of very low resistances is possible with Kelvin’s Double Bridge

Answer : Turbine used for low head is Kaplan turbine.

Description : At very low frequencies a series R-C circuit behaves as almost purely?

Answer : At very low frequencies a series R-C circuit behaves as almost purely capacitive.

Description : In an AC. circuit, a low value of kVAR compared with kW indicates?

Answer : In an AC. circuit, a low value of kVAR compared with kW indicates high power factor.

Answer : In a low power factor wattmeter the pressure coil is connected to the load side of the current coil.

Answer : The primary reason for low power factor is supply system is due to installation of induction motors.

Answer : A low utilization factor for a plant indicates that plant is used for stand by purpose.

Answer : To protect most of the electrical equipment handling low power, the types of relays used are thermocouple, electronic and bimetallic.

Description : The efficiency of a transformer, under heavy loads, is comparatively low because?

Answer : The efficiency of a transformer, under heavy loads, is comparatively low because copper loss becomes high in proportion to the output.

Description : What is the definition of extra low voltage?

Answer : Extra-low voltage (ELV) is an electricity supply voltage in a range which carries a low risk of dangerous electrical shock.

Description : What is the difference between a line voltage and low voltage control system?

Description : What is considered low voltage and high voltage?

Description : At which time power factor of the induction motor is low?

Answer : The power factor of the inducction motor is low at the time of starting as compare to while the induction motor is running.

Description : For a prototype low pass filter, the series and shunt elements are respectively _____.

Answer :  For a prototype low pass filter, the series and shunt elements are respectively inductive and capacitive.

Description : The values of L and C for a low pass filter with cut off frequency of 2.5 KHz and operating with a terminated load resistance of 450 Ohm are given by  (a) 57.3 mH; 0.283 μF (b) 28.66 μH; 0.14 μF (c) 114.64 mH; 0.566 mF (d) 50.23 mH; 0.632 mF

Answer : The values of L and C for a low pass filter with cut off frequency of 2.5 KHz and operating with a terminated load resistance of 450 Ohm are given by 57.3 mH; 0.283 μF

Description : Low pass filter with cut off frequency of 100 kHz and high pass filter with cut off frequency of 50 kHz are connected in tandem, the resultant filter is Low pass filter with cut off frequency of 100 kHz ... kHz Band pass filter with pass band from 50 kHz to 100 kHz. None of the above.

Answer : Low pass filter with cut off frequency of 100 kHz and high pass filter with cut off frequency of 50 kHz are connected in tandem, the resultant filter is Band pass filter with pass band from 50 kHz to 100 kHz.

Description : Angles in degrees of pole locations of 4th order Butterworth low pass filter approximation from either real axis are  A) +45,-45,+30,-30 B) +67.5,-67.5,+45,-45 C) +30,-30,+22.5,-22.5 D) +67.5,-67.5,+22.5,-22.5 

Description : Write short notes on multiple fruits.  

Answer : Ans: Multiple fruits are developed from inflorescence. These are of two types known as Sorosis and Syconus. 1. Sorosis: It is developed from Spadix, Spike and Catkin inflorescences. In Morus and ... . Each female flower develops into an achene. The fleshy part is peduncle.Ex: Ficus species.

Description : Write short notes on aggregate fruits.  

Answer : Ans: Fruits developed from bi or multicarpellary apocarpous ovaries are called as aggregate fruits. Ovary of each carpel develops into a small fruit called as fruitlet. All the fruitlets are attached to ... and Nelumbo, etaerio of follicles as in Magnolia and etaerio of drupes as in Rubus. 

Description : Write short notes on single fruit like inflorescence. 

Answer : Ans: Hypanthodium is fruit like inflorescence. The peduncle is condensed, fleshy cup like hollow structure with an apical opening. The flowers are small, sessile unisexual and monochlamydeous. Inner surface of ... flowers. Opening of flowers is not in a definite order. Ex: Ficus species

Description : Write short notes on leaves that help in vegetative reproduction

Answer : Ans: Leaves which have epiphyllous buds help in vegetative reproduction. Such leaves are called as reproductive leaves. In Bryophyllum, notches of leaf margins have epiphyllous buds which upon shedding strike ... buds arise at the leaf tip and in Begonia from the wounded regions of leaf.  

Description : Write short notes on storage roots  

Answer : Ans: Modified roots that become swollen due to accumulation of excessive food materials are called as storage roots. They may be developed from tap root or tap root system which appear in conical shape in ... , fruiting and seed setting. Hence they must be harvested at the end of first year.   

Description : Write short notes on fire extinguishing methods adopted in electrical engineering. 

Answer : Stand 6 to 8 feet away from the fire and follow the four-step PASS procedure. If the fire does not begin to go out immediately, leave the area at once. Always be sure ... fire causing the particles to expand chemically inhibiting combustion and expelling the oxygen thereby smothering the flames. 

Description : Write short notes on 3 phase AC system.

← Prev Question Next Question →
editAsk a Question
...