Questions & Answers
Ask a Question
Questions & Answers
Text to speech
Ask a Question
The secondary output voltage of a saturable core frequency meter is the function of
May 25, 2018
The secondary output voltage of a saturable core frequency meter is the function of (a) only frequency (b) only primary voltage (c) both (a) and (b) (d) None of above
to add a comment.
Can you give answer to this question ?
Upload an image:
Email me at this address if my answer is selected or commented on:
Email me if my answer is selected or commented on
Privacy: Your email address will only be used for sending these notifications.
to add a comment.
← Prev Question
Next Question →
Welcome to AskOrAnswerMe.com , where you can ask questions and receive answers from other user. Feel free to ask any question. Help everyone by giving best answer to the questions.
The frequency of a voltage at the secondary is -
What happens to the voltage in the secondary when the frequency of the supply in the primary is decreased?
When The dc converter in figure shown has a resistance load of R = 10 Ω and the input voltage is Vs 220 V the converter switch remains on, its voltage drop is Vo -2 V. The chopping frequency is fI K sW Vs If the duty cycle is 50%, determine: (a) the average output voltage V (b) the RMS output voltage Vo (c) the converter efficiency (d) the effective input resistance of the converter
When secondary of a current transformer is open-circuited its iron core will be?
The ratio of the primary to secondary voltage of a transformer is 2:1. The saving in the turns of weight of...
A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum
For a pulse transformer, the material used for its core and the possible turn ration from primary to secondary
The output power of a filter is 100 mW, when the signal frequency is 6 kHz. When the frequency is increased...
In d.c. choppers, for periodic time T, the output voltage can be controlled by frequency modulation by varying
In air-core cable the surge voltage travels approximately at the speed of light and a cable of 100m length gives a delay of a. 0.666μsec b. 0.333μsec c. 1.555μsec d. 1μsec
The main function of the transformer used in the output of a power amplifier is
If a step function is applied to the input of a system and the output...
When the turns ratio of a transformer is 20 and the primary ac voltage is 12 V, the secondary voltage is?
If the secondary turns of a transformer are doubled and at the same time primary voltage is
The voltage applied to the H.V. side of a transformer during S.C. test is 2% of the rated voltage. The core loss
In a transformer, low voltage winding is placed near the core in case of concentric windings so
What is the output voltage of a battery if 12 J of energy is expended in moving 1 C of charge?
What is the output voltage of a battery if 6 J of energy is expended in moving 1 C of charge?
What is the output voltage of a battery if 10 J of energy is expended in moving 1.25 C of charge?
An air core transformer has primary and secondary inductors of 8mH and 10 mH respectively...
A system has 14 poles and 2 zeros in its open -loop transfer function. The slope of its highest frequency ...
In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:
The input frequency of a bridge rectifier is 50 its output frequency will be
Draw a block diagram of electronic energy meter. Write function of each block.
In a 3-phase extra-high voltage cable, a metallic screen around each core insulation is
why is it that when the frequency of a voltage in an inductor increases current decreases?
The output clock frequency for a frequency division circuit having 11 flipflops with an input clock frequency ..
In a certain loaded transformer, the secondary voltage is one-fourth the primary voltage. The secondary
The ammeter reading connected across a CT secondary is 3 A and the voltage reading connected across ...
State the function and shape of following parts used in induction type energy meter: i) Series magnet ii) Shunt magnet iii) Al disc iv) Brake magnet
In a battery, the difference between the no-load voltage and the measured voltage output is called ________
The output of a feedback control system must be a function of?
In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary
Which of the following connection of transformers will give highest value of secondary voltage ?
The core used in high frequency transformer is usually?
In a Weston frequency meter, the magnetic axes of the two fixed coils are?
In a vibrating reed frequency meter the natural frequencies of two adjacent reeds have a difference of?
the classification of cables. (i) According with voltage levels. (ii) According to numbers of core.
Draw the diagram and explain the working of ferrodynamic type frequency meter.
State the application of phase sequence indicator; clip on ammeter, frequency meter & P.F. meter.
The duty ratio of a step-up chopper with an output voltage of 200 V from a 80 V dc source, is
The output voltage of a battery drops from 100 V with zero load current to 80 V when load current is 2 A.
In a D.C. generator in case the resistance of the field winding is increased, then output voltage will?
separately excited dc motor controlled by chopper with a frequency of 500hz and source voltage of 230v and rated value of motor is ...
What is the Output voltage of Op-amp for input voltage of Vi1=150 μV,Vi2=140 μV if the amplifier ...
Which one of the following frequency meter is suitable for measuring radio frequency?
The frequency stability of the oscillator output is maximum in _____.
If a transformer primary is energised from a square wave voltage source, its output voltage will be a: ...
A Weston frequency meter is?
Which is not measured by frequency meter ?
Install Android APP